685964
17
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
17
EN
Water Supply Requirements
A cold water supply with water pressure
between 138 kPa and 827 kPa (1.4-8.4 kgf/cm²)
is required to operate the water dispenser. If the
refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a
booster pump to compensate for the low
pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 138 kPa to 827 kPa
(1.4-8.4 kgf/cm²)
WARNING
Unplug the appliance before carrying out any
work on connecting the water line. Failure to
do so may cause electric shock.
Only connect the water line to a cold water
supply. Failure to do so may cause the water
filter to malfunction. Water hammer (water
banging in the pipes) in house plumbing can
cause damage to appliance parts and can
lead to water leakage or flooding.
Connecting the water line must only be
installed by a qualified plumber and in
accordance with local legislation and
regulations governing water quality.
NOTE
This water line installation is not covered by
the appliance warranty.
Connecting to the Appliance
1
Unscrew the metal threaded collar nut at
the back of the appliance and place it over
one end of the water tube.
2
Firmly push the water tube onto the water
inlet valve and tighten up the collar nut.
Connecting to the Water Filter
There are two types of filters. The methods of
connection are different. One has a threaded
plastic nut fitting and the other uses a self
locking push fit connectors. The filter is marked
with the direction of the water flow from the
water tap to the appliance.
<Nut Type>
1
Unscrew the threaded connector and place
it over the end of the cut section of pipe
coming from the appliance. Push the pipe
over the end of the filter that the flow arrow
points to and tighten up the threaded
connector.
2
Repeat the same process on the other end
of the filter using the remainder of the water
tube.
<Push fit Connector Type>
1
Firmly push the water tube connected from
the appliance into the end that has the
arrow pointing outward. Push the tube all
the way in (approx. 10-12 mm).
2
After inserting the tube securely into the
filter, fit the locking clip into position under
the pull up collar.
3
Repeat on the other end of the filter using
the remainder of the water tube.
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

lg-gsx961

Suche zurücksetzen

  • Wenn man den Side by Side kurz mal beim Transport ins Haus quer legt und danach wieder richtig aufrecht hinstellt. Muss dann lange gewartet werden um das Netzteil anstecken zu können oder geht dies gleich. Eingereicht am 29-5-2020 16:17

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für LG GSX961 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von LG GSX961

LG GSX961 Bedienungsanleitung - Deutsch - 46 seiten

LG GSX961 Bedienungsanleitung - Holländisch - 48 seiten

LG GSX961 Bedienungsanleitung - Alle Sprachen - 1250 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info