INSTALLER’S SETTING OPTIONS
199
ENGLISH
198
INSTALLER’S SETTING OPTIONS
h Celsius control unit setting value
- 00: 1°C control
- 01: 0.5°C control
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for 3
seconds or longer to enter the installer function.
● At the Code field select setting code value ‘17’.
- You can press ‘▲’, ‘▼’ button to change the code value.
● At the Value 1 field, press the ‘▲’, ‘▼’ button to select Celsius control unit setting value, and
then press ‘Done’ button to complete the Celsius control unit setting.
- If you do not press ‘Done’ button, your changes will not be applied.
Celsius control unit setting (air conditioner)
Celsius control unit setting you to set the temperature adjustment unit in the unit of 1˚C or 0.5˚C.
Emergency Heater Setting(air conditioner)
This function is only available on some products
This function will set the Emergency Heater Setting.
Emergency Heater is used to heat the space in emergency case such as heat pump error.
Emergency heat is in place of and does not supplement heat pump.
h Emergency Heater setting Function sets following conditions:
1) Emergency Heater operation while in error or outdoor unit operates cooling cycle.
2) Emergency Heater operation in Low Ambient temperature
3) Fan speed setting during Emergency Heater operation
● Press and hold ‘wireless remote controller signal receiver part’ of the remote controller for
3seconds or longer to enter the installer function.
● Select remote controller Emergency heater setting code value ‘18’.
You can press ‘▲’, ‘▼’ button to change the code value.
● In value1, use ‘▲’, ‘▼’ button to select Emergency heater setting value.
h Setting value #1(Heater Operation while in error or outdoor unit operates cooling cycle.)
- 000 : Not use
- 001 : Use
h If 000 is set at this stage, setting value #2 & setting value #3 will not be available.
h If no buttons are pressed for about 60 seconds after the setting, it automatically exits from the
setting mode.
