Bedienungsanleitung Liebherr CMes 502 (Seite 4 von 5) (Englisch)

597566

Zoom out

Zoom in

Vorherige Seite

1/5

Nächste Seite

Wall mounting

The appliance can be wall-mounted.

There are two mounting holes

at the top of the back of the

appliance.

Make sure the wall and the

fasteners can withstand the

weight of the appliance when

fully loaded.

Inserting the grid shelves

The knurled screws supplied are used

to support the grid shelves.

Screw the knurled screws into

the desired position inside the

appliance to the left and right

and insert the grid shelves.

The lower grid shelf only

requires two screws at the

front. The rear part of this grid

shelf rests on the ledge of the

interior container.

Electrical connection

Only operate the appliance with alternating current (AC).

The permissible voltage and frequency are indicated on the type

plate. The position of the type plate is shown in the section entitled

Description of the appliance.

The socket must be properly earthed and protected by a fuse.

The tripping current of the fuse must be between 10 A and 16 A.

The socket must not be situated behind the appliance and must

be easily accessible.

Do not connect the appliance using an exten-

sion cable or extension socket.

Do not use stand-alone inverters (conversion

of direct current to alternating/three-phase

current) or energy-saving plugs. Risk of dam-

age to the electronic control system!

Setting the temperature

Set the temperature inside the ap-

pliance using the temperature

control.

When the control is turned to

"7", the temperature inside the

appliance is at its lowest.

Set the control between "1" and

"7" as required.

Appliance

dimensions

Setting up

• Avoidpositioningtheapplianceindirectsunlightornearcook-

ers, radiators and similar sources of heat.

• Theflooronwhichtheappliancestandsshouldbehorizontal

and level. Compensate for uneven floors with the adjustable

feet.

• StandardEN378specifiesthattheroominwhichyouinstall

your appliance must have a volume of 1 m

per8gofR600a

refrigerant used in the appliance, so as to avoid the formation of

inflammable gas/air mixtures in the room where the appliance

is located in the event of a leak in the refrigerant circuit. The

quantity of refrigerant used in your appliance is indicated on

the type plate on the inside of the appliance.

• Theremustbeagapofatleast20cmbetweentheupperedge

of the appliance and the ceiling. Always ensure that there is good

ventilation and that the outward flowing air is able to escape.

Do not cover ventilation

openings or grille.

Switching the appliance on and off

You are recommended to clean the interior of the appliance before

switching it on for the first time (see Cleaning).

Switching the appliance on

Connect the appliance to the mains - the appliance is switched on.

Important

Once the mains plug has been inserted, the refrigeration

unit may not come on until up to 8 minutes later. This is

required to protect the electronic controls.

Switching the appliance o

Pulloutthemainsplugorsetthetemperaturecontrol

to 0.

Important

When the temperature control is turned to "0", the refrig-

eration system is switched off, but the appliance is not

completely disconnected from the mains. Before cleaning,

always disconnect the appliance from the mains. Remove

the plug.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr CMes 502 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr CMes 502

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info