Bedienungsanleitung Liebherr SUIGN 1554 (Seite 10 von 12) (Englisch)

715491

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Defect Cause Remedy

DEMO shines in

the temperature

display.

The outer surfaces

of the appliance

are warm*.

→The heat of the refrigeration circuit

is used to prevent condensate from

forming.

uThis is normal.

The temperature is

not cold enough.

→The door of the appliance is not

properly closed.

uClose the door of the appliance.

→ Insufficient ventilation. uKeep ventilation grille clear, and clean it.

→The ambient temperature is too

high.

uSolution: (see 1.2 Appliance range of use) .

→The appliance was opened too

frequently or for too long.

uWait to see whether the appliance reaches the required

temperature by itself. If not, please contact the after

sales service (see 6 Maintenance) .

→Too much fresh food was placed

inside without SuperFrost.

uSolution: (see 5.7 SuperFrost)

→ The temperature is incorrectly set. uSet the temperature to a colder setting and check after

24 hours.

→The appliance is too close to a

source of heat (stove, heater etc).

uChange the position of the appliance or the source of

heat.

→The appliance was not inserted

properly into the recess.

uCheck whether the appliance was inserted correctly and

the door closes properly.

Dashes (“- -”) are

shown on the

display.

→The freezing temperature has risen

above zero degrees because of a

power cut or power interruption.

uSee also "Power failure" and " "

The door seal is

defective or needs

to be replaced for

another reason.

→The door seal can be replaced. It

can be replaced without the need

for special tools.

uContact Customer Service (see 6 Maintenance) :

The unit has iced

up or condensation

has formed.

→The door seal may have also

slipped out of its groove.

uCheck to ensure that the door seal is seated properly in

the groove.

8 Decommissioning

8.1 Switching off the appliance

uPress On/Off button Fig. 2 (1) for

approx. 2 seconds.

wA long beep is emitted. The temperature

display is dark. The appliance is switched off.

wIf the appliance cannot be switched off, the

child lock function is active (see 5.1 Child

proofing) .

8.2 Taking the appliance out of service

uEmpty the appliance.

uSwitch off the appliance (see 8 Decommissioning) .

uRemove mains connector.

uClean the appliance (see 6.2 Cleaning the appli‐

ance) .

uLeave the door open to prevent odour.

9 Disposal

9.1 Preparing appliance for disposal

Liebherr uses batteries in some of its appli‐

ances. In the EU, for environmental reasons,

legislation obliges the end user to remove

these batteries before disposing of old appli‐

ances. If your appliance contains batteries, a

corresponding notice is attached.

Lamps If you can remove the lamps yourself without

destroying them, also remove these before

disposal.

uTake the appliance out of operation. (see 8.2 Taking the

appliance out of service)

uAppliances with batteries: remove the batteries. For

description, see Maintenance chapter.

uIf possible: remove lamps without destroying them.

Decommissioning

10 * Depending on model and options

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr SUIGN 1554 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr SUIGN 1554

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info