Bedienungsanleitung Liebherr UIKP 1550 (Seite 12 von 14) (Englisch)

715457

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

Defect Cause Remedy

The temperature is

not cold enough.

→The door of the appliance is not

properly closed.

uClose the door of the appliance.

→ Insufficient ventilation. uKeep ventilation grille clear, and clean it.

→The ambient temperature is too

high.

uSolution: (see 1.2 Appliance range of use) .

→The appliance was opened too

frequently or for too long.

uWait to see whether the appliance reaches the required

temperature by itself. If not, please contact the after

sales service (see 6 Maintenance) .

→ The temperature is incorrectly set. uSet the temperature to a colder setting and check after

24 hours.

→The appliance is too close to a

source of heat (stove, heater etc).

uChange the position of the appliance or the source of

heat.

→The appliance was not inserted

properly into the recess.

uCheck whether the appliance was inserted correctly and

the door closes properly.

The internal light

does not come on.

→ The appliance is not switched on. uSwitch the appliance on.

→The door was open for longer than

15 minutes.

uThe internal light switches itself off automatically after

about 15 minutes if the door is open.

→ The LED illumination is faulty or the

cover is damaged: WARNING

Risk of injury due to electric shock!

There are live electrical parts under the cover.

uOnly ever have the inside LED light replaced or repaired

by customer service or trained personnel.

WARNING

Risk of injury from LED bulb!

The light intensity of the LED light corresponds to hazard

group RG 2.

If the cover is defective:

uDo not look directly into the light from close range. It

cause injury to the eyes.

The door seal is

defective or needs

to be replaced for

another reason.

→The door seal can be replaced. It

can be replaced without the need

for special tools.

uContact Customer Service (see 6 Maintenance) :

The unit has iced

up or condensation

has formed.

→The door seal may have also

slipped out of its groove.

uCheck to ensure that the door seal is seated properly in

the groove.

8 Decommissioning

8.1 Switching off the appliance

uPress the On/Off button Fig. 2 (1) until the display goes

dark. Release button.

wIf the appliance cannot be switched off, the child lock

function is active (see 5.1 Child proofing) .

8.2 Taking the appliance out of service

uEmpty the appliance.

uSwitch off the appliance (see 8 Decommissioning) .

uRemove mains connector.

uClean the appliance (see 6.2 Cleaning the appli‐

ance) .

uLeave the door open to prevent odour.

9 Disposal

9.1 Preparing appliance for disposal

Liebherr uses batteries in some of its appli‐

ances. In the EU, for environmental reasons,

legislation obliges the end user to remove

these batteries before disposing of old appli‐

ances. If your appliance contains batteries, a

corresponding notice is attached.

Lamps If you can remove the lamps yourself without

destroying them, also remove these before

disposal.

uTake the appliance out of operation. (see 8.2 Taking the

appliance out of service)

Decommissioning

12 * Depending on model and options

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Liebherr UIKP 1550 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Liebherr UIKP 1550

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info