593894
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
HOW TO ENGAGE AND DISENGAGE
THE ALARM AND THE HOURLY TIME
SIGNAL
1 Press Button C in the time/calendar display
to show the alarm display. The alarm display
is shown while Button C is kept pressed.
2 With each press of Button B while keeping
Button C pressed, the engagement and
disengagement of the alarm and the hourly
time signal are made as follows:
Changeover in the alarm display
24-hour
12-hour
[Keeping Button C pressed]
* When the “A” (AM)/“P” (PM) mark disap-
pears, the calendar or the alarm display is
shown in the 24-hour indication.
When EL button is pressed and released in the
time/calendar or stopwatch display, or in the
alarm setting or time/calendar setting function,
the electroluminescent light evenly illuminates
the display for 4 seconds for easy viewing in the
dark.
EL button
Notes:
1. The watch works with one battery. When the
light begins to lose its luminance, this is an
indication that the battery is depleted. We
recommend that you change the battery
before the watch itself stops.
2. If the light is used continuously for a long time,
the battery life may be less than the specified
period.
BATTERY CHANGE
The miniature battery which powers your watch
should last as individually specified below.
However, because it is inserted at the factory,
the actual life of the battery once in your
possession may be less than the specified
period. Be sure to replace the battery to
prevent any possible malfunction as soon as it
runs down. To replace the battery, we
recommend taking the watch to a local watch
repair shop.
EL button
(for Cal. YK32 & Z001 only)
ILLUMINATING LIGHT
(for Cal. YK30, YK31, YK32, YK33,
YK34 & Z001)
BATTERY
LIFE
(Approx.)
CAL. NO.
BATTERY
Note: If the alarm is used for more than 30
seconds a day (and/or the illuminating
light for more than 4 seconds a day for
Cal. YK30, YK31, YK32, YK33, YK34 & Z001),
the battery life may be less than the
specified period.
Z003
SONY CR1020, 1 piece
4 years
SONY CR2032, 1 piece 8 years
Z001
2 years
YK34
YK32
SONY CR1620, 1 piece
SONY CR1220, 1 piece
2 years
YK31
SONY CR2016, 1 piece
YK30
YK33
Z002
Y922
CARE OF YOUR LORUS WATCH
This watch contains precise electronic
components. Never attempt to open the case
or remove the back cover.
BATTERY
CAUTION
Do not expose the old battery to fire or
recharge it. Keep it at a place beyond
the reach of children. If a child swallows
it, consult a doctor immediately.
WATER RESISTANT
* If your watch is 200 M/20 BAR, 100 M/10 BAR
or 50 M/5 BAR water resistant, it is so
indicated on the dial/case back.
Do not operate the buttons when the watch
is wet.
If the watch is exposed to salt water, rinse it
in fresh water and then wipe it thoroughly
dry.
NO NO NO
YES
YES
YES NO NO
YES YES NO
Condition
of use
Accidental
contact
with water,
such as
splashes
and rain
Swimming
and taking
a shower
Skin
diving
Scuba
diving
Indication
on the dial/
case back
No
Indication
NO
NO
NO
YES
WATER
RESISTANT
WATER
RESISTANT
(50M/5 BAR
)
WATER
RESISTANT
100M/10 BAR
or above
(
NO
(
Caution:
Leather straps are not water resistant except so
indicated, even if the watch head is water
resistant.
ALLERGIC REACTION
Because the case and band touch the skin
directly, it is important to clean them regularly.
If not, shirt sleeves may be stained and those
with delicate skin may develop a rash. Please
wear the watch with some play to avoid any
possible allergic reaction. If you develop a rash
on your wrist, stop wearing and consult a
physician.
MAGNETISM
Your watch will be adversely affected by strong
magnetism. Keep it away from close contact
with magnetic objects.
SHOCKS AND VIBRATIONS
Your watch may be worn for normal sports
activities, but be careful not to drop it or hit it
on hard surfaces.
TEMPERATURE
Your watch is preadjusted so that constant
accuracy may be insured a normal
temperature.
SERVICE
When your LORUS watch requires repair or
sevicing, please see the enclosed WARRANTY/
GUARANTEE.
Printed in China
Cal. Y922:
10 years
Z009
Cal. YK30:
2 years
Cal. YK33:
2 years
Cal. Z002:
5 years
Cal. Z009:
2 Years
“A” (AM)
B
C
Hour
Alarm display
Minute
The alarm rings at the designated time for 30
seconds and stops. However, the alarm can be
stopped manually by pressing Button C in any
display.
HOW TO SET THE TIME/CALENDAR
Time/calendar setting indicator
1 Press Button A to activate the time/calendar
setting function. (The time/calendar setting
indicator and the second digits start
flashing.)
2 Selection of the digits to be adjusted (flash-
ing) is made in the following order by pressing
Button B.
3 One digit (flashing) is advanced with each
press of Button C. (The digits except seconds
are advanced quickly by keeping Button C
pressed.)
Second setting
Press Button C in accordance with a time
signal. The seconds are reset to “00” and
start immediately.
When the seconds count any number
from “30” to “59” and Button C is pressed,
one minute is added and the seconds are
immediately reset to “00”.
4 After all the adjustments are completed,
press Button A to return to the time/calendar
display.
Note: When setting the hour digits, be sure to
check that the “A” (AM)/“P” (PM) mark is
correctly set.
Second Minute
MonthHour
Day Date
A
Alarm is engaged.
Hourly time signal is
disengaged.
Alarm and hourly time
signal are disengaged.
Hourly time signal is
engaged.
Alarm is disengaged.
ALARM TEST
The alarm can be tested with a beeping sound
by pressing Buttons B and C at the same time in
the time/calendar display.
B
C
Alarm and hourly time
signal are engaged.
HOW TO STOP THE ALARM
HOW TO CHANGE OVER THE 12-HOUR
AND 24-HOUR INDICATIONS
In the calendar or the alarm display, each press
of Button A changes over the time indication
display from the 12-hour to the 24-hour and vice
versa.
Changeover in the calendar display
24-hour
A
A
12-hour
[Keeping Button B pressed]
A
A
LUMIBRITE WATCH
If your watch is a LORUS LUMIBRITE watch, it
has following features.
LORUS LUMIBRITE watches absorb and store light
energy from natural and artificial light sources
and emit light in the dark. They are made of
environmentally friendly material, and therefore,
are harmless to human beings and the
environment.
With a full charge, LORUS LUMIBRITE watches
glow in the dark hours longer than conven-
tional luminous watches of this type. If ex-
posed to a light of more than 500 lux (i.e.,
the brightness of a typical office) for approxi-
mately 10 minutes, or direct sunlight for 2
minutes, they will glow for hours.
Since LORUS LUMIBRITE watches emit the light
they store, the brightness will decrease
gradually over time. The length of time they
will glow may also differ slightly depending
on such factors as the brightness of and
distance from the light source used to charge
the watch.
BLUE 10.8.18, 5:19 PMPage 2 Adobe
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Lorus Z002 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Lorus Z002

Lorus Z002 Bedienungsanleitung - Deutsch - 2 seiten

Lorus Z002 Bedienungsanleitung - Holländisch - 2 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info