743786
5
Zoom out
Zoom in
Vorherige Seite
1/7
Nächste Seite
II_Pulse_09_eng
Page 5 di 8
Mounting Instructions
BOLTWORK REQUIREMENTS AND MOUNTING INSTRUCTION
The bolt force applied must not exceed 1kN (contact the manufacturer if a force greater than that shown
is applied).
Use only the screws provided, screwing it in order to firmly fixed the lock to the mounting surface.
In the LOCKED position, there should be approximately 1 mm clearance between the
lock bolt and the cavity in the blocking bar of the boltwork. The lock bolt must move
freely into the cavity.
In OPEN position, there should be minimum
3mm and maximum 5 mm clearance between
the lock bolt and the bloching bar of the
boltwork.
Any component that is fixed to the bolt, must be approved before use.
Mount the keyboard by following the installation instructions.
The opening movement of the shaft must be inserted for a minimum of 10 mm and a maximum of 15
mm inside the lock.
ATTENTION: to prevent damage to the cable, do NOT insert the shaft
until the lock lid, but leave some margin to allow the movement of the cable.
Make sure the cable is fully inserted and locked into the groove on the shaft of the movement.
Remove any residue derived from shaft cutting, which could damage the cable.
Plug the cable connector into the square hole in the base of the lock and it comes out the other side.
Secure the cable in the proper groove on the lock cover
(not stretch)
and fix the same, using the
appropriate mounting screws.
Insert the connector of the entry unit in the outer position “ENT”.
Check that the connector
is completely seated (To remove the connector, lift it up and carefully pull it out).
Insert ALKALINE 9V battery in the keyboard or in the battery holder. A series of beeps during opening
indicates that the battery is low and needs to be replaced.
MOTORLOCK – DIMENSIONS
:
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für M-Locks Pulse Pro wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von M-Locks Pulse Pro

M-Locks Pulse Pro Bedienungsanleitung - Holländisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info