Bedienungsanleitung Makita EH7500W (Seite 9 von 132) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch)

448395

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

Fuel and oil mixture

- The engine of the hedge trimmer is a high-efﬁciency two-stroke engine.

It is run with a mixture of fuel and two-stroke engine oil. The engine is designed

for unleaded regular fuel with a min. octane value of 91 ROZ.

In case no such fuel is available, you can use fuel with a higher octane value.

This will not damage the engine, but may cause poor operating behaviour.

A similar situation will arise from the use of leaded fuel.

To obtain optimum engine operation and to protect your health and the

environment, only unleaded fuel should be used!

- For lubricating the engine use a two-stroke engine oil (quality grade: TSC-3),

which is added to the fuel.

The engine has been designed for use with MAKITA two-stroke engine oil and a

mixture ratio of 50:1 only to protect the environment. In addition, a long service

life and a reliable operation with a minimum emission of exhaust gases is

guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (MAKITA

2-stroke engine oil), otherwise the reliable function of the hedge trimmer cannot

be guaranteed.

- The correct mixture ratio:

Gasoline: Speciﬁed two-stroke engine oil = 50 : 1 or

Gasoline: Other manufacturer’s two-stroke engine oil = 25 : 1

recommended

NOTE: For preparing the fuel-oil mixture, ﬁrst mix the entire oil quantity with half of

the fuel required in an approved canister which meets or exceeds all local

code standards. Then add the remaining fuel.

Thoroughly shake the mixture before ﬁlling it into the hedge trimmer’s tank.

Do not add more engine oil than speciﬁed to ensure safe operation. It will

only result in a higher production of combustion residues which will pollute

the environment and clog the exhaust channel in the cylinder as well as the

mufﬂer. In addition, the fuel consumption will rise and the performance will

decrease.

Handling petroleum products

Utmost care is required when handling fuels. Fuels may contain substances similar

to solvents. Refuel either in a well ventilated area or outdoors. Do not inhale fuel

vapors, avoid any contact of fuel or oil with your skin.

If your skin comes in contact with these substances repeatedly and for an extended

period of time, it will desiccate.

Various skin diseases may result. In addition, allergic reactions are known to occur.

Eyes can be irritated by contact with oil, fuel etc.

If oil, fuel, etc., comes into your eyes, immediately wash them with clear water.

If your eyes are still irritated, see a doctor immediately!

FUELS/REFUELING

Observe the Safety Instructions on page 5.

1,000 cm

(1 litter)

5,000 cm

(5 litter)

10,000 cm

(10 litter)

20 cm

40 cm

100 cm

200 cm

400 cm

Gasoline Oil

50:1

50:1 25:1

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Makita EH7500W Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Makita EH7500W

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info