494220
53
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
103 104
Using a Tripod
The Memo Clip on the Back Cover fits the top
cover of the film box and can also be used for
other reminders.
Memo Clip
When You Think Something Might Be “Faulty”
When using a tripod with 3/8” screw (instead of
1/4” screw) remove the small screw A from the
tripod screw hole on the bottom of the body
using a plus screwdriver, then use a coin to
remove the tripod screw adapter bushing B.
Tripod / Memo Clip
In the conditions below or when the LCDs display the items listed in
pages 105 and 106, they are not necessarily faults. Check the camera
referring the descriptions below.
- Unable to release the shutter
Check to see if the batteries are installed. Check to see if the batteries are dead.
Check to see if the power is on (the shutter release selector lever should be set to
S” or “C” position).
Check to see if the dark slide has been removed.
Check to see if the film back is set to the correct ISO sensitivity (ISO indicator is not
blinking).
Check to see if the camera is advancing the film.
Check to see if the rear door is open when film is not loaded.
- The viewfinder does not show LCD read-outs.
Check to see if the batteries are installed. Check to see if the batteries are dead.
Check to see if the power is on (the shutter release selector lever is other than in the
L” position).
Check to see if the magazine is installed.
If the camera has not operated for longer than 15 seconds, the viewfinder LCD read-
outs will automatically disappear.
- The dark slide cannot be pulled out
Check to see if the batteries are installed. Check to see if the batteries are dead.
The magazine is not mounted onto the camera.
- Film cannot be wound.
Check to see if the batteries are dead.
Check to see if the film still has some remaining frames.
Check to see if there is film loaded into the camera.
Check to see it the camera is in multiple exposure mode.
This camera employs a microcomputer. It is possible that the camera may mal-
function when exposed to static electricity or the like. In this case, turn OFF the
camera power and then remove the batteries. Reinstall the batteries, then turn
the power on. If the camera does not function properly after these steps, contact
our sales office or service center.
A
B
Kodak
Professional
1 2 0
EKTACHROME
Color Reversal Film
53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mamiya 645 AFD III wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info