Bedienungsanleitung Marantz CD6004 (Seite 34 von 38) (Englisch)

453889

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

ENGLISH

Speciﬁcations

n Audio performance

• Analog output

Channels: 2 channels

Playable frequency range: 2 Hz – 20 kHz

Playable frequency response: 2 Hz – 20 kHz

S/N: 110 dB

Dynamic range: 100 dB

Harmonic distortion: 0.002 % (1 kHz)

Wow & ﬂutter: Crystal accuracy

• Output level

Signal type: 2.2 V RMS stereo

Headphone output: 28 mW/32 Ω (variable maximum)

• Digital output

output level (cinch JACK): 0.5 Vp-p (75 Ω)

output level (optical): -19 dBm

• Optical Readout System

Laser: AlGaAs

Wave length: 780 nm

Signal type: 16-bit linear PCM

Sampling frequency: 44.1 kHz

n General

Power supply: AC 230 V, 50/60 Hz

Power consumption: 32 W

Standby: 0.3 W or less

Operating temperatures: +5 ˚C – +35 ˚C

Operating humidity: 5 – 90 % (without dew)

z For purposes of improvement, speciﬁcations and design are subject to change without notice.

Problem Cause Corrective action Page

Sound cannot be heard

even when an iPod is

connected.

•Models prior to 5th generation

iPods are not supported.

•For details, see “Supported

iPod Models”.

•The ampliﬁer and speakers are

not connected correctly.

•Connect the cables correctly.

(See the instruction manual

for the ampliﬁer.)

•The ampliﬁer’s function or

selector switch is not set to

“CD” or “AUX” or such (to

whatever you have connected

this unit to).

•Switch the ampliﬁer’s

function or selector switch

to “CD” or “AUX” or such

(to whatever you have

connected this unit to).

(See the instruction manual

for the ampliﬁer.)

–

•The ampliﬁer’s volume control

is set at the minimum level.

•Adjust the ampliﬁer volume.

(See the instruction manual

for the ampliﬁer.)

–

It takes time for USB

memory device to be

read.

•When connecting a high-

capacity USB memory device,

it will take time to read

depending on its capacity.

Several minutes may be

required for reading when

using a high-capacity device.

•Wait until reading is

completed.

–

There is no sound output

from this unit when

music ﬁles stored on a

USB memory device or

iPod are played.

•The “USB OUT” setting is set

to “2 Digital”.

•Change the “USB OUT”

setting to “1 Analog”.

GRemote controlH

Problem Cause Corrective action Page

Remote control

operation is not

possible.

•The distance between this unit

and the remote control is too

great.

•Move closer to this unit, and

operate the remote control

within the operating range.

•There is an obstacle between

this unit and the remote

control.

•Remove the obstacle. 4

•The remote control’s batteries

are dead.

•Replace all batteries with

new ones.

•The remote control sensor is

being subjected to strong light.

•Move so that the remote

control sensor is not

subjected to strong light.

•The switch on the back of the

REMOTE CONTROL is on

“EXTERNAL”.

•When using this unit

independently, set the

switch to “INTERNAL”.

1.CD6004N_ENG_最終検図完_0701.indd 29 2011/07/01 15:45:56

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz CD6004 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Marantz CD6004

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info