Bedienungsanleitung Marantz MA 6100 (Seite 4 von 9) (Englisch)

522818

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

ENGLISH

HOW TO CONNECT A PLUG

The wires in the mains lead are coloured in accordance with

the following code:

BLUE—”NEUTRAL” (“N”)

BROWN—”LIVE” (“L”)

1. The BLUE wire must be connected to the terminal which is

marked with the letter “N” or coloured BLACK.

2. The BROWN wire must be connected to the terminal which

is marked with the letter “L” or coloured RED.

3. Do not connect either wires to the earth terminal in the plug

which is marked by the letter “E” or by the safety earth

symbol

or coloured green or green-and-yellow.

Before replacing the plug cover, make certain that the cord

grip is clamped over the sheath of the lead — not simply over

the two wires.

Recording and playback of some material may require per-

mission. For further information refer to the following:

– Copyright Act 1956

– Dramatic and Musical Performers Act 1958

– Performers Protection Acts 1963, and 1972

– Any subsequent statutory enactments and orders

PRECAUTIONS

The following precautions should be taken when operating the

equipment.

GENERAL PRECAUTIONS

When installing the equipment ensure that:

– the ventilation holes are not covered.

– air is allowed to circulate freely around the equipment.

– it is placed on a vibration-free surface.

– it will not be exposed to excessive heat, cold, moisture or

dust.

– it will not be exposed to direct sunlight.

– it will not be exposed to electrostatic discharges.

In addition, never place heavy objects on the equipment.

If a foreign object or water does enter the equipment, contact

your nearest dealer or service center.

Do not pull out the plug by pulling on the mains lead; grasp the

plug.

It is advisable when leaving the house, or during a thunder-

storm, to disconnect the equipment from the mains supply.

FOREWORD

This section must be read carefully before any connection is

made to the mains supply.

WARNINGS

Do not expose the equipment to rain or moisture.

Do not remove the cover from the equipment.

Do not insert anything into the equipment through the

ventilation holes.

Do not handle the mains lead with wet hands.

EQUIPMENT MAINS WORKING SETTING

Your Marantz product complies with the household power and

safety requirements in your area.

“/02” Version product can be powered by 230 V AC only.

IMPORTANT

This apparatus is fitted with an approved moulded 13 Amp

plug. To change a fuse in this type of plug proceed as follows:

1. Remove fuse cover and fuse.

2. Fix new fuse which should be a BS1362 5A, A.S.T.A. or BSI

approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should

be cut off and an appropriate plug fitted in its place.

If the mains plug contains a fuse, this should have a value of

5A. If a plug without a fuse is used, the fuse at the distribution

board should not be greater than 5A.

NOTE:

The severed plug must be destroyed to avoid a possible

shock hazard should it be inserted into a 13A socket else-

where.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Marantz MA 6100 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info