522862
13
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
10
ENGLISH
Connecting the remote control connectors
When you use this unit connected to Marantz audio components, it
sends control signals to operate each component.
n Connection
Use the remote connection cable (supplied with a Marantz
audio component you want to connect) to connect the REMOTE
CONTROL OUT terminal of this unit to the REMOTE CONTROL IN
terminal of the component to be connected.
n Setting
Set the remote control switch located on the rear panel of the
connected audio component to “EXTERNAL” or “EXT.” to use
this feature.
This setting will disable remote sensor reception of the connected
audio component.
To operate the connected audio component, point the remote
control at the remote sensor of this unit.
Advanced operations
REMOTE CONTROL
IN
OUT
RC OUT
CD player
Option unit
(such as remote control receiver unit)
OUTPUTINPUT
Setting Auto standby mode
With the Auto standby mode ON, this unit will automatically enter
the Auto standby mode after about 30 continuous minutes of no
output from the speakers or headphones.
SOURCE DIRECT
Press and hold <SOURCE DIRECT> for at least 5 seconds.
Auto standby mode is switched between On and Off.
Auto standby mode “Off”
Power indicator
Flashes once
Auto standby mode “On”
Power indicator
Flashes three times
NOTE
Perform the operation using the buttons on the unit. You cannot
perform the operation using [SOURCE DIRECT] on the remote control.
The default setting for the Auto standby mode is OFF.
This unit will automatically enter Auto standby mode after about
continuous 30 minutes in the following conditions.
No output from the selected input source.
No operation performed on the remote control.
No operation of <SPEAKERS A/B>, <POWER AMP DIRECT>,
<SOURCE DIRECT>
or <INPUT SELECTOR>.
Connecting pre out connectors
If you use a power amplifier, connect it as shown below, and then
you can use this unit as a preamplifier.
For connecting speaker systems, refer to the instruction manual
supplied with the power amplifier to be used.
R
L
R
L
Power-amplifier
To input
connectors
NOTE
NEVER insert the short-circuiting pin plug into the PRE OUT
terminals. Doing so could result in damage.
Signals are output from the PRE OUT terminals even when using
headphones.
1.PM8004U_ENG_0701.indd 10 2010/07/01 17:46:14
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Marantz PM8004 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Marantz PM8004

Marantz PM8004 Bedienungsanleitung - Französisch - 17 seiten

Marantz PM8004 Bedienungsanleitung - Spanisch - 17 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info