161710
26
Zoom out
Zoom in
Vorherige Seite
1/30
Nächste Seite
23
ENGLISH
OPERATION
ABOUT BALANCED JACKS
q The balanced output connector uses a XLR connector.
w The XLR connector for professional use is internally wired
in either of the following two systems.
1. USA system (Pin w = COLD, Pin e = HOT)
wq
e
GND
HOT
COLD
2. European system (Pin w = HOT, Pin e = COLD)
wq
e
GND
COLD
HOT
e This unit uses the 1. USA system.
When a preamp or main amplifier adopting the European
system is connected using a cable with XLR balanced
connectors, the reproduced signal may be inverted of
phase.
In this case, refer to “ANALOG OUTPUT CONNECTOR
PHASE SWITCHING”, and set so that the correct phase
is used.
ANALOG OUTPUT CONNECTOR
PHASE SWITCHING
By digitally processing audio signals read by this unit, it is
possible to perform phase inversion without changing the
tone quality.
Inverted signals are output from the UNBALANCED output
connector, and the BALANCED output connector interchanges
between HOT and COLD signals.
As the USA system has been adopted for the BALANCED
output connector, if the amp or other device used with this unit
is a European system device, a phase inversion cable would
normally need to be used to playback with the correct phase.
However, by pressing the INV. PHASE button on this unit, you
can listen to the correct phase without replacing the cable.
Moreover, if a disc that has been recorded with the incorrect
phase is being played, you can play it in the correct phase by
pressing the INV. PHASE button.
To change the mode
Every time the INV. PHASE button on the front of this
unit is pressed, the phase of the signal being output
from the ANALOG OUTPUTS connector (BALANCED,
UNBALANCED) is inverted. The indicator flashes during
inverted playback.
Correct phase
Inverted phase
Caution:
Phase switching is only possible when the LCD display is
turned on.
If switching is performed during playback, sound output
is stopped for approximately one second to prevent the
occurrence of unnecessary noise.
• The information after this operation is stored by the last
memory function even after the power is switched OFF.
SA-11S2_N_01_Eng.indd 23SA-11S2_N_01_Eng.indd 23 07.8.8 9:35:06 AM07.8.8 9:35:06 AM
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Marantz sa 11 s2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Marantz sa 11 s2

Marantz sa 11 s2 Bedienungsanleitung - Holländisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info