Bedienungsanleitung master BC 180 (Seite 5 von 124) (Alle Sprachen)

588464

Zoom out

Zoom in

Vorherige Seite

1/124

Nächste Seite

►►2. UNPACKING

►2.1. Remove all packaging materials

used to wrap and deliver the appliance

and dispose of them in compliance with

the Standards in force.

►2.2. Extract all items from the packaging.

►2.3. Verify if damage undergone during

transport. If the appliance appears

damaged, inform the dealer, where the

purchase was made, immediately.

►►3. ASSEMBLY

The device is equipped with wheels to

facilitate handling. Depending on the model,

wheels can be found already installed or not.

Components equipped with relative nuts

and bolts are found inside the packaging

(Fig. 1).

►►4. OPERATION

WARNING: Thoroughly read the

”INFORMATION REGARDING SAFETY”,

before switching the appliance on.

WARNING: Only use clean water to

prevent failures or other anomalies.

WARNING: Verify if your electronic

system is earthed correctly. Connection

to the mains must be made in compliance

with the National Standards in force.

Power the appliance only with voltage

and frequency as specied on the data

plate.

NOTE: These models can be connected

to the water mains, by connecting the

pipe to the tting (Fig. 10).

►►4.1. SWITCHING ON:

►4.1.1. Open the tank door (Fig. 2).

►4.1.2. Fill the tank with water (Fig. 3);

water level must be within MIN and MAX

level of the graduated scale, placed at the

side of the appliance (Fig. 4), in order to

prevent risks.

►4.1.3. Close the tank door (Fig. 5).

►4.1.4. Connect the power plug to the

mains (Fig. 6).

►4.1.5. Press the ON/OFF button to switch

on the appliance (Fig. 9).

►►4.2. CONTROL PANEL, USE

AND FUNCTIONS FOR MODEL BC

60 (Fig. 7-8):

►ON/OFF: It allows switching ON or OFF

the appliance.

►SPEED: Allows increasing or decreasing

the appliance ventilation speed. Three

speeds can be selected - LOW, MID and

HIGH.

►COOL: It enables or disables the cooling

mode.

►SWING: It enables or disables the

automatic vertical oscillation of the aps

to direct the air ow.

►ANION: It enables or disables the

ionisation mode, i.e. release of negative

ions into the environment, in order to

make air healthier.

►TIMER: It enables or disables the timer

of the appliance automatic switch-OFF.

Intervals can be of half-hour up to 12

hours.

►►4.3. CONTROL PANEL, USE

AND FUNCTIONS FOR BC 180 (Fig.

7-8):

►ON/OFF: It allows switching ON or OFF

the appliance.

►COOL: It enables or disables the cooling

mode. Pay attention to the fact that the

fan is switched on one minute after the

initiation of wetting of the cooling panel

with water.

►BLAST: Pressing the COOL button

again switches off the water vaporization

function, and only the fan is in the operating

mode.

►SPEED: Allows increasing or decreasing

the appliance ventilation speed. Three

speeds can be selected - LOW, MID and

HIGH.

►SWING: It enables or disables the

automatic vertical oscillation of the aps

to direct the air ow.

►TIMER DELAYED START: Enables

the commencement of the operation

of the device with a delay, after several

hours. When the green light -POWER- is

switched on only, press the TIMER until

the required number of hours of delay (1-

24) appears.

Figures and texts of this book are protected by COPYRIGHT.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

master BC 180 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info