785624
14
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
14 EN / SCM20 & SCM40 PWM User’s Manual
4 TROUBLE SHOOTING
If you cannot solve a problem with the aid of this chapter, contact your local Mastervolt Service Centre. See
www.mastervolt.com/technical-support. Make sure you have the following information present if you have to contact your local
Mastervolt Service Center to solve a problem: Article and serial number; see section 1.4
Malfunction Possible cause What to do?
No display function Battery voltage is abnormal Check battery voltage. Battery voltage must be
10~15V for 12V systems or 20~30V for 24V
systems.
Reversed polarity of the Battery Check wiring to battery
No voltage at Load
output
Fault condition See below error codes E1 ~E5
Wrong setting of the Load mode Check settings of the Load mode (section 2.6)
Short circuit at Load output Switch off all loads, remove short circuit. Load
output will automatically resume after 1 minute.
Overload at Load output Reduce the connected load. Load output will
automatically resume after 1 minute.
Battery voltage is too low; see section 2.6
for configuration of the Low voltage
disconnect function.
Reduce load connected to the batteries and
charge batteries. Load output will automatically
resume after 1 minute.
Overcharge, battery voltage is too high
(>15.5/31.0V)
Check batteries. Check other charging systems.
Use the battery temperature sensor.
Over temperature Check cooling of the Solar Chargemaster
No battery charging
during daytime
Batteries are full Nothing.
No power from the PV-modules.. Check wiring to PV-modules. Check for loose
connections, short circuit or incorrect polarity
Damaged battery temperature sensor Check battery temperature sensor (if applied)
Output voltage too low,
charger supplies
maximum current
Load that is connected to the batteries is
larger than charger can supply.
Reduce load taken from the batteries.
Batteries not 100% charged Measure battery voltage. After some time this will
be higher.
Wrong battery type setting Check settings (see section 2.6).
Battery is discharged too
fast
Battery capacity reduced due to sulphation
or due to plate corrosion
Charge and recharge a few times, this might help.
Check battery and replace if necessary.
Too low charger capacity or battery
capacity or too high load
Check balance between charger capacity, battery
capacity and load
Batteries are too warm,
gassing
Defective battery (short circuit in cell) Check battery and replace if necessary.
Battery temperature too high Use the battery temperature sensor.
Charge current too high for battery Check specifications of battery for maximum
allowed charge current
Wrong battery type setting Check settings (see section 2.6).
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mastervolt Solar ChargeMaster SCM40 PWM wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info