Bedienungsanleitung Maxdata SN 40 (Seite 79 von 85) (Englisch)

650496

Zoom out

Zoom in

Vorherige Seite

1/85

Nächste Seite

78 79MAXDATA SN 40 M1 – User GuideProtecting Local Disks

 Note

If you are recovering a system disk, the system to which you are recovering the data must be identical

to the original system. For example, if the original system had a particular type of network adapter,

the system to which you are recovering the data must have the exact same type of network adapter.

Otherwise, the recovered files will not operate properly.

15. If you selected the backup of a disk in step 9, go to step 17.

If you selected the backup of a partition in step 9, select “Restore to a partition” to recover

to an existing partition on the selected disk, or select “Clear all partitions and create new” to

delete all the existing data on the selected disk and recover only the selected partition.

16. If you selected “Restore to a partition” in step 15, select the partition where you want to

recover the data, and then select “Next”. (Otherwise, go to step 17.)

17. Select “Yes” to confirm the action.

Caution

This overwrites any existing data on the selected disk. Although you can subsequently recover different

data, you cannot recover the original data.

The status screen displays the progress of the recovery. You can cancel it at any time by

selecting “Abort”. However, this leaves the disk or partition in an incomplete state (some of

the data will have been recovered, but not all of it).

18. When the completion screen appears, review the results and do one of the following:

To do this Do this

Review information about any sectors that

were not successfully recovered

Select “Failed Sectors”, review the displayed

information, and select “Back”.

Recover another disk or partition Select “Continue”.

If you want to recover a different backup of the

same computer from the same storage system,

select “Yes” to retain the current configuration

settings and return to step 9.

If you want to recover a different computer’s

backup, or if you want to recover a backup

of the same computer from another storage

system, select “No” to modify the current

configuration settings and return to step 5.

Restart the computer

Unplug the network cable from the computer

and select “Finish”. Remove the CD.

19. When the computer restarts, use the appropriate procedure for your system to configure the

computer to boot from the local hard disk once more.

20. Start Client Backup and Recovery and remove protection from the recovered disk or partition

(as described in “Removing Protection” on page 80).

Since the computer is disconnected from the network, you might see messages about the

backup being offline. This is normal.

21. Plug the network cable back into the computer and restart the computer.

22. Protect the recovered disk once again (as described in “Protecting Your Disks” on page 68).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Maxdata SN 40 Seite 79

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info