701385
19
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
INP UT
6V
0.2 V
40H z
180 Hz
R
L
INPUT LEVE L
LOW PASS
0dB 12d B
BASS BOOST
15H z
55H z
SUBS ONIC
REM OTE
SLA VE
IN
MAS TER
OUT
SLA VE
IN
MAS TER
OUT
INP UT
6V
0.2 V
40H z
180 Hz
R
L
INPUT LEVE L
LOW PASS
0dB 12d B
BASS BOOST
15H z
55H z
SUBS ONIC
REM OTE
SLA VE
IN
MAS TER
OUT
SLA VE
IN
MAS TER
OUT
INTERCONNECTION MASTER
Connect the RCA lineouts of the headunit with the RCA jacks LINE INPUT of the amplifier with appropriate high-value RCA cables.
If your headunit is equipped with a additional subwoofer lineout (SUB OUT), it is recommended to use this lineout.
Connect the remote wire (REM) to the remote terminal (REM) of the MASTER amp.
Connect the bass remote wire only on the REMOTE port of the MASTER amp.
INTERCONNECTION SLAVE
Connect the RCA jacks MASTER OUT of the MASTER amp with the RCA jacks SLAVE IN of the SLAVE amp with appropriate
high-value RCA cables.
Connect the remote wire (REM) of the remote terminal (REM) of the MASTER amp with the remote terminal (REM) of the SLAVE amp.
Use therefore cable with a minimum profile section of 0,5 mm
2
.
INTERCONNECTION SUBWOOFER
• Attend page 22.
SETTINGS MASTER
• The SLAVE IN/MASTER OUT switch should be in MASTER OUT position.
Observe the informations of LOW PASS, SUB SONIC, LEVEL, BASS BOOST, FREQ RANGE and BASS REMOTE on page 18.
SETTINGS SLAVE
• The SLAVE IN/MASTER OUT switch should be in SLAVE IN position
In SLAVE mode all controllers of the SLAVE amp are without function.
Only the already modified audiosignal of the MASTER amp will be amplified.
INTERCONNECTION EXAMPLE Master/Slave Mode
Connect Stereo RCA output (L/R or SUB OUT)
of the headunit with the LINE INPUT L & R
of the MASTER amp
Connect the bass remote controller and the remote terminal
at the amplifier (MASTER) with the enclosed cable.
Switch position MASTER OUT
SLAVE
MASTER
Switch position SLAVE IN
Connect Stereo RCA output MASTER OUT of
the MASTER amp with the RCA input SLAVE IN
of the SLAVE amp.
1.
I N T E R C O N N E C T I O N E X A M P L E S
NSC750
19
MAXMIN
PROTECTPOWER
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für MB Quart NSC750 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info