661773
10
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
10 [EN]
14. TROUBLESHOOTING
Trouble
Cause
Solution
Unit does not operate
No power to the unit
Plug in the unit; check power at
outlet
Switch not turned ON
Turn ON the switch
Completely filled water tank
Water tank must be emptied and
installed again
Doesn’t dehumidify
Ambient temperature is lower than +5°C
Under this condition the dehumidifier
becomes inefficient. It is
recommended to switch off the
dehumidifier
Ambient temperature exceeds 35°C
Under this condition the compressor is
overloaded and switches off
automatically. It is recommended to
switch off the dehumidifier.
The ambient air humidity is lower than 50 %
Under this condition the dehumidifier
becomes inefficient. It is
recommended to switch off the
dehumidifier
The air filter is strongly soiled
The air filter must be exchanged
Not enough time to dry
Allow more time to dry
Compressor will not start
Overload protector is defective
Contact a specialized workshop
Running capacitor is defective
Contact a specialized workshop
The fan is out of operation
The dehumidifier is running a defrost cycle
The dehumidifier will switch on the
fan automatically after some minutes.
If not, the malfunction must be
repaired by a Meaco approved
workshop.
Fan not running
Contact a Meaco approved workshop.
Unit continuously in defrost
and you can see an ice block
on the evaporator
Defective control assembly
Contact a Meaco approved workshop.
The room temperature is lower than +5ºC
Assure that the device is only set up
in rooms with temperatures above
+5°C.
Defective bypass relay valve
Contact a Meaco approved workshop.
Unit does not defrost
Defective temperature sensor
Contact a Meaco approved workshop.
Defective control assembly
Contact a Meaco approved workshop.
Defective bypass relay valve
Contact a Meaco approved workshop.
Time counter does not run
Switch not turned ON
Turn ON the switch.
Completely filled water collecting tank
The water collecting tank must be
emptied and installed again.
Defective time counter
Contact a Meaco approved workshop.
15. MAINTENANCE
Always turn off the power and disconnect the main cable before performing maintenance procedures. All service
procedures below are to be executed with the unit unplugged. Perform before each use or as needed.
INSPECT ELECTRICAL SYSTEM
Inspect the electrical cord for damage at regular intervals.
KEEP OUT DUST
Keep dust from surfaces and volumes to dry
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Meaco 96Lm wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info