551332
23
Zoom out
Zoom in
Vorherige Seite
1/25
Nächste Seite
ENGLISH ENGLISH
20
21
You might meet abnormal working of this STB with various reasons. Check the following
which may help you.
Problem Possible causes What to do
LED on the front panel fail to
light up/is not lit.
No picture or sound.
Bad picture/blocking error
No startup menu on screen after
turning on STB for the first time.
The remote control is not wor-
king.
Poor picture quality or Less
channels in scanning.
You have forgotten your pass-
word.
Check if the main supply cable is
plugged into the power socket.
Adjust the dish. Check the sig-
nal strength indicator in one of
the channels search submenus.
Check the cable connections,
LNB and other equipment con-
nected to LNB & receiver, or
adjust dish. Replace the LNB.
Replace the cable.
Adjust the dish. Connect an at-
tenuator to LNB input. Change
to a larger dish. Change LNB
with lower noise factor. Replace
the LNB.
Switch the TV to the appropriate
AV input.
Change the batteries (both).
Aim the remote control at the
STB. Check that nothing blocks
the front panel. Check if LED
indicator on the front panel is
showing the time, press the po-
wer button to switch off standby
mode.
Change the LNB power to
14V/19V in Antenna setup
menu.
Contact the dealer or Service
Provider. They will help you set
it up again.
Main supply cable is not con-
nected.
Satellite dish is not aiming to
satellite accurately. No signal or
weak signal. The LNB is faulty.
The cable is faulty.
Satellite dish is not aiming to the
satellite accurately. Signal too
strong. Satellite dish is too small.
LNB noise factor too high. The
LNB is faulty.
The system is connected by
SCART cable and the TV is not in
AV/ EXT mode.
Battery exhausted. Remote con-
trol is not aimed correctly STB is
in standby mode.
Low LNB power or signal loss in
cable.
5. Additional Information5. Additional Information
5.1 Troubleshooting 5.2 Technical Specication
Tuner & Demodulator
MPEG
A/V und Data In/Out Connector
Power Supply
Physical Specication
Frequency Range
Input Connector
Signal Level
RF Impedance
IF Band width
LNB Power
LNB Polarization
LNB Tone Switch
DiSEqC Control
Demodulation
Symbol Rate
FEC Decode
950 MHz to 2150 MHz
F-type, IEC 169-24, Female
-25 to -65 dBm
75Ω¸unbalanced
55 MHz/8Hz(Per 5Msps)
Vertical : +13 V, 14V +/-5%
Horizontal : +18 V, 19V+/-5% Current : 500 mA Max. Overload Protection
22KHz+/-2KHz, 0.6Vpp+/-0.2V
Version 1.0/1.2 Compatible, Tone burst A/B
QPSK/8PSK
1~45Ms/s/SCPC,MCPC
1/2, 2/3, 3/4, 5/6 and 7/8 with Constraint Length K=7
Transport Stream
Profile Level
Input Rate
Aspect Ratio
Video Resolution
Audio Decoding
Audio Mode
Sampling
MPEG-4/H.264, MPEG-2 ISO/IEC 13818
MPEG-4/AVC, MPEG-2 MP@ML, MP@HL
15 Mbit/s Max
4:3, 16:9
720 x 576, 720 x 480, 1280 x 720, 1920 x 1080
MPEG / MusiCam Layer I & II
Single channel/Dual channel/Joint stereo/Stereo
32, 44.1 and 48 KHz
HDMI
LNB IF Input
SPDIF
HDMI OUTPUT
F type, IEC 169-24 Female
COAXIAL OUTPUT
Input Voltage
Power in use
Power in Standby
Protection
100 - 240V AC, 50/60Hz,
Max. 6 W
0.5 W
Separate internal fuse. Input shall have lightening Protection
Weight (net)
Operating Temp
Storage Temp
ca. 360 g
0° to + 40°
-40° to + 65°
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Megasat HD 600 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info