Bedienungsanleitung Mercedes S-Class Coupe 2017 (Seite 335 von 338) (Englisch)

703598

335

Zoom out

Zoom in

Vorherige Seite

1/338

Nächste Seite

Filling capacities

The following values refer to an oil change

including the oil filter.

Model Capacity

Mercedes‑AMG

S 63 4MATIC

9.0 US qt (8.5 l)

Mercedes‑AMG

S 65

11.1 US qt (10.5 l)

All other models

8.5 US qt (8.0 l)

Additives

Do not use any additives in the engine oil.

This could damage the engine.

Brake fluid

WARNING

The brake fluid constantly absorbs moisture

from the air. This lowers the boiling point of

the brake fluid. If the boiling point of the brake

fluid is too low, vapor pockets may form in the

brake system when the brakes are applied

hard. This would impair braking efficiency.

There is a risk of an accident.

You should have the brake fluid renewed at

the specified intervals.

Comply with the important safety notes for ser-

vice products when handling brake fluid

(

Y page 330).

The brake fluid change intervals can be found in

the Maintenance Booklet.

Only use brake fluid approved by Mercedes-

Benz according to MB-Freigabe or MB-Approval

331.0.

Information about approved brake fluid can be

obtained at any qualified specialist workshop or

on the Internet at

http://bevo.mercedes-benz.com.

Have the brake fluid regularly replaced at a

qualified specialist workshop and the replace-

ment confirmed in the Maintenance Booklet.

Coolant

Important safety notes

WARNING

If antifreeze comes into contact with hot com-

ponents in the engine compartment, it may

ignite. There is a risk of fire and injury.

Let the engine cool down before you add anti-

freeze. Make sure that antifreeze is not spilled

next to the filler neck. Thoroughly clean the

antifreeze from components before starting

the engine.

Only add coolant that has been premixed

with the desired antifreeze protection. You

could otherwise damage the engine.

Further information on coolants can be found

in the Mercedes-Benz Specifications for Ser-

vice Products, MB BeVo 310.1, e.g. on the

Internet at http://bevo.mercedes-benz.com.

Or contact a qualified specialist workshop.

Always use a suitable coolant mixture, even

in countries where high temperatures prevail.

Otherwise, the engine cooling system is not

sufficiently protected from corrosion and

overheating.

Have the coolant regularly replaced at a

qualified specialist workshop and the replace-

ment confirmed in the Maintenance Booklet.

The coolant is a mixture of water and anti-

freeze/corrosion inhibitor. It is responsible for

the following:

Anti-corrosion protection

Antifreeze protection

Raising the boiling point

If the coolant has antifreeze protection down to

-35 ‡ (-37 †), the boiling point of the coolant

during operation is approximately 266 ‡

(130 †).

The antifreeze concentrate/corrosion inhibitor

concentration in the engine cooling system

should:

be at least 50%. This will protect the engine

cooling system against freezing down to

approximately -35 ‡ (-37

†).

not exceed 55% (antifreeze protection down

to -49 ‡ [-45 †]). Otherwise, heat will not be

dissipated as effectively.

Service products and filling capacities

333

Technical data

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mercedes S-Class Coupe 2017 Seite 335

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mercedes S-Class Coupe 2017

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info