Bedienungsanleitung Mia EW3662T (Seite 15 von 17) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

714842

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

Prodomus

 If you want to reboil the water, let cool down the water a few minutes before the appliance

can be switched on again. The boil process can be interrupted at any time by positioning

the switch to OFF.

 In order to open the lid, pull the unlocking button. In order to prevent scald injuries, pay

attention that neither hot water nor hot steam escape.

 The appliance is protected by a security system, which automatically switches off the

kettle, if it is switched on by mistake without water or with not enough water (protection

against dry running).

With temperature pre-selection

 In order to fill in water, always lift off the reservoir from the base station.

 Open the cap and fill the reservoir with fresh water. The quantity of water filled in has to be

between MIN and MAX at the inside located water level scale – don't exceed or under-run.

 Close the lid carefully until it is locked. The automatic switch-off can work only with a

properly closed cap.

 Put the kettle on its base station and set the thermostat-switch to the desired temperature

between MIN and MAX (around 30° and 90°, not MIN).

 Switch On/Off button on to position I. The appliance heats up the water to the adjusted

temperature. The pilot lamp lights.

 Once the chosen temperature is reached, the kettle will switch-off automatically.

 You may switch-off manually at any time.

 The middle position of the temperature display corresponds to approximately 50-60°

Celsius, the MAX position corresponds to approximately 90-100° Celsius.

 After use empty the water kettle. Never leave water inside to avoid lime residues.

 After use always switch off and unplug for safety reason.

 The kettle will automatically switch off and the control lamp will also switch off. To reboil

simply set the switch to "I" position again after a few minutes. You may interrupt the boiling

at any time by switching to the "O" position again.

 The appliance is equipped with a safety system and will automatically switch off, should

the kettle be accidentally operated without or with not enough water.

 Don't let water remain in the appliance to avoid limestone. The decalcification interval

depends on the hardness of the water and the frequency of use. Decalcification should be

carried out every 1 – 3 month. Please use common decalcification agent (commercially

available) and read and follow its instructions of use closely.

 The guarantee covers manufacturing and material faults whereas limestone removing as

part of cleaning and maintenance is not covered.

 Never allow the connector parts to become wet nor immerse the kettle into water.

 Wipe the unit only with a damp cloth. Furring up is a common problem in hard water areas,

and it is recommended that a de-scaling fluid is used to remove the deposits.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mia EW3662T Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info