Bedienungsanleitung Microlife BP A100 Plus en T (Seite 6 von 121) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch, Polnisch)

536804

Zoom out

Zoom in

Vorherige Seite

1/121

Nächste Seite

3. Taking a Blood Pressure Measurement using this

Instrument

4. Appearance of the Heart Arrhythmia Indicator for

early Detection

This symbol AM indicates that certain pulse irregularities were

detected during the measurement. In this case, the result may

deviate from your normal blood pressure – repeat the measure-

ment. In most cases, this is no cause for concern. However, if the

symbol appears on a regular basis (e.g. several times a week with

measurements taken daily) we advise you to tell your doctor.

Please show your doctor the following explanation:

5. Traffic Light Indication in the Display

The bars on the left-hand edge of the traffic light display

show

you the range within which the indicated blood pressure value lies.

Depending on the height of the bar, the readout value is either within

the normal (green), borderline (yellow) or danger (red) range. The

•

The individual results are not displayed. Your blood pressure

will only be displayed after all 3 measurements are taken.

•

Do not remove the cuff between measurements.

•

If one of the individual measurements was questionable, a

fourth one is automatically taken.

Checklist for taking a reliable measurement

1. Avoid activity, eating or smoking immediately before the

measurement.

2. Sit down for at least 5 minutes before the measurement and

relax.

3. Always measure on the same arm (normally left).

4. Remove close-fitting garments from the upper arm. To avoid

constriction, shirt sleeves should not be rolled up - they do

not interfere with the cuff if they are laid flat.

5. Always ensure that the cuff is positioned correctly, as shown

in the pictures illustrated on the short instruction card.

• Fit the cuff closely, but not too tight.

• Make sure that the cuff is 2 cm (0.75 inch) above your

elbow with the tube on the inside of your arm.

• Support your arm so it is relaxed.

• Ensure that the cuff is at the same height as your heart.

6. Press the ON/OFF button 1 to start the measurement.

7. The cuff will now pump up automatically. Relax, do not move

and do not tense your arm muscles until the measurement

result is displayed. Breathe normally and do not talk.

8. When the correct pressure is reached, the pumping stops

and the pressure falls gradually. If the required pressure was

not reached, the instrument will automatically pump some

more air into the cuff.

During the measurement, the heart symbol

flashes in the

display and a beep sounds every time a heartbeat is detected.

10.

The result, comprising the systolic

and the diastolic

blood

pressure and the pulse

is displayed and longer beep is heard.

Note also the explanations on further displays in this booklet.

11. When the measurement has finished, remove the cuff and

pack it into the instrument as shown in Fig. II.

12. Enter the result in the enclosed blood pressure pass and

switch off the instrument. (The monitor does switch off auto-

matically after approx. 1 min.).

)

You can stop the measurement at any time by pressing the

ON/OFF button (e.g. if you feel uneasy or an unpleasant

pressure sensation).

)

If the systolic blood pressure is known to be very high

it can be an advantage to set the pressure individually. Press

the ON/OFF button after the monitor has been pumped up to

a level of approx. 30 mmHg (shown on the display). Keep the

button pressed until the pressure is about 40 mmHg above

the expected systolic value – then release the button.

Information for the doctor on frequent appearance of the

Arrhythmia indicator

This instrument is an oscillometric blood pressure monitor that

also analyses pulse frequency during measurement. The instru-

ment is clinically tested.

The arrhythmia symbol is displayed after the measurement, if

pulse irregularities occur during measurement. If the symbol

appears more frequently (e.g. several times per week on

measurements performed daily) we recommend the patient to

seek medical advice.

The instrument does not replace a cardiac examination, but

serves to detect pulse irregularities at an early stage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Microlife BP A100 Plus en T Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info