Bedienungsanleitung Microlife BP B2 Easy (Seite 5 von 69) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Türkisch)

773521

Zoom out

Zoom in

Vorherige Seite

1/69

Nächste Seite

3BP B2 Easy EN

Manual inflation

In case of high systolic blood pressure (e.g. above

135

mmHg)

it can be an advantage to set the pressure individually. Press the ON/

OFF button after the monitor has been pumped up to a level of

approx. 30 mmHg (shown on the display). Keep the button pressed

until the pressure is about 40 mmHg above the expected systolic

value – then release the button.

How do I evaluate my blood pressure?

The triangle on the left-hand edge of the display AO points at the

range within which the measured blood pressure value lies. The

value is either within the optimum (white), elevated (hatched gray)

or high (black) range. The classification corresponds to the

following ranges defined by international guidelines (ESH, ESC,

JSH). Data in mmHg.

The higher value is the one that determines the evaluation.

Example: a blood pressure value of 140/80 mmHg or a value of

130/90 mmHg indicates «blood pressure too high».

Appearance of the Irregular Heartbeat (IHB) Symbol

This symbol AN indicates that an irregular heartbeat was detected.

In this case, the measured blood pressure may deviate from your

actual blood pressure values. It is recommended to repeat the

measurement.

4. Data Memory

This device always stores the last result at the end of the measure-

ment. To recall the reading, press and hold the ON/OFF button 1

while the device is switched off. Release the button as soon as all

display elements are shown. The stored result will then be shown,

indicated with the letter «M» AP.

5. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol

will flash as soon as the device is switched on (partly filled battery

displayed). Although the device will continue to measure reliably, you

should obtain replacement batteries.

Flat battery – replacement

When the batteries are flat, the battery symbol AL will flash as soon

as the device is switched on (flat battery displayed). You cannot

take any further measurements and must replace the batteries.

1. Open the battery compartment 5 at the back of the device.

2. Replace the batteries – ensure correct polarity as shown by the

symbols in the compartment.

Which batteries and which procedure?

Use 4 new, long-life 1.5 V, size AA alkaline batteries.

Do not use batteries beyond their date of expiry.

Remove batteries if the device is not going to be used for a

prolonged period.

Using rechargeable batteries

You can also operate this device using rechargeable batteries.

Only use «NiMH» type reusable batteries.

Batteries must be removed and recharged when the flat

battery symbol appears. They should not remain inside the

device as they may become damaged (total discharge as a

result of low use of the device, even when switched off).

Always remove the rechargeable batteries if you do not

intend to use the device for a week or more.

Batteries cannot be charged in the blood pressure monitor.

Recharge batteries in an external charger and observe the

information regarding charging, care and durability.

6. Using a Mains Adapter

You can operate this device using the Microlife mains adapter

(DC 6V, 600 mA).



Only use the

Microlife

mains adapter available as an original

accessory appropriate for your supply voltage.

Ensure that neither the mains adapter nor the cable are

damaged.

1. Plug the adapter cable into the mains adapter socket 4 in the

blood pressure monitor.

2. Plug the adapter plug into the wall socket.

Range Systolic Diastolic Recommendation

1. blood pressure

too high ≥135 ≥85 Seek medical

advice

2. blood pressure

elevated 130 - 134 80 - 84 Self-check

3. blood pressure

normal <130 <80 Self-check

Information for the doctor in case of repeated appearance of

the IHB symbol:

This device is an oscillometric blood pressure monitor that also

measures the pulse during blood pressure measurement and

indicates when the heart rate is irregular.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Microlife BP B2 Easy Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info