Bedienungsanleitung Midea MFAD-Serie (Seite 5 von 12) (Englisch)

588095

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

owner’s manual

Use the system in the following temperature for safe and

effective operation.The Max operation temperature for

the air conditioner.(Cooling/Heating)

3. AIR CONDITIONER OPERATIONS AND

PERFORMANCE

If air conditioner is used outside the above conditions, it may

cause the unit to function abnormally.

Room relative humidity should be less than 80%. If the air

conditioner is over it , the surface of the air conditioner may

condense water . Please set the vertical air flow louver to its

maximum angle (vertically to the floor), and set HIGH speed.

Optimum performance will be achieved within these

operating temperature range.

Fig. 5-1

Fig. 5-2 Fig. 5-3

4. HINTS FOR ECONOMICAL OPERATION

The following should be noticed to ensure an economical operation.

(Refer to corresponding chapterfor details)

5. ADJUSTING AIR FLOW DIRECTION

Auto-swing

Press SWING button, the louver will swing up and down

automatically.

When cooling

Adjust the louver downwards. (horizontally)(Refer to Fig.5-2).

When heating

Adjust the louver vertically(Refer to Fig.5-3)

Three-minute protection feature

A protection feature prevents the air conditioner from being

activated for approximately 3 minutes when it restarts immedi-

ately after operation.

Power failure

Power failure during operation will stop the unit completely.

The OPERATION lamp on the indoor unit will start

flashing when power is restored

To restart operation, push the ON/OFF button on the

remote controller.

Lightning or a car wireless telephone operating nearby

may cause the unit to malfunction.

Disconnect the unit with the power and then connect the unit

with the power again. Push the ON/OFF button on the remote

controller to restart operation.

Adjust the air flow direction properly to avoid winding toward

your body.

Adjust the room temperature properly to get a comfortable

situation and to avoid supercooling and superheat.

In cooling, close the curtains to avoid direct sunlight.

To keep cool or warm air in the room, never open doors or

windows more often than necessary.

Set the timer for the desired operating time.

Never put obstructions near the air outlet or the air inlet. Or it

will cause lower efficiency, even a sudden stop.

If you don't plan to use the unit for a long time, please discon-

nect power and remove the batteries from the remote control-

ler. When the power switch is connected, some energy will be

consumed, even if the air conditioner isn't in operation. So

please disconnect the power to save energy. And please

switch the power on 12 hours before you restart the unit to

ensure a smooth operation.

A clogged air filter will reduce cooling or heating efficiency,

please clean it once two weeks.

Manual Swing

Press Air Direction button,the louver can be fixed at a desir-

ed angle.The louber swing (upward or downward ) to a

certain angle for each press.

CAUTION

Table 3-1

0°C ~ 30°C / 32 °F~86°F

17°C ~ 32°C

( 62 °F ~ 90°F)

17°C ~ 32°C

( 62 °F ~ 90°F)

Cooling operation

Drying operation

Heating operation

(cooling only type without)

Mode

Temperature

Outdoor

temperature

(for the models with low

temperature cooling system)

temperature

0°C ~ 50°C / 32 °F~122°F

-15°C ~ 50°C / 5 °F~122°F

-15°C ~ 24°C / 5 °F~76°F

With this new technology, the dipsplay area will appear EC (if

applicable) and the LED indication lamps continue flashing

when the outdoor unit detects refrigerant leakage.

Louver Angle Memory Function(optional):

For some models, the machine is special designed with louver

angle memory function.Power failure during operation or

pressing the ON/OFF button on the remote controller will stop

the unit completely.When the power restores or pressing the

ON/OFF button on the remote controller again,the unit restarts

automatically with the previous open angle of the horizontal

louver by the memory function.So we strongly recommend that

the open angle of the horizontal louver should not be set too

small,in case the condensed water forms and drops from the

horizontal louver. Press the Manual control button and the open

angle of the horizontal louver will be restored to the standard

angle.

Refrigerant Leakage Detection(optional):

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Midea MFAD-Serie Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Midea MFAD-Serie

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info