Bedienungsanleitung Mitsubishi RLD012A002G (Seite 30 von 34) (Englisch)

587227

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

– 29 –

Notice

Airﬂ ow is not blown out when starting the HEATING

operation.

RUN light blinks slowly

(1.5 sec ON, 0.5 sec OFF)

Airﬂ ow has stopped to prevent blowing out of cold air until the

indoor heat exchanger has warmed up. (2 to 5 min.) (HOT

KEEP program)

Airﬂ ow is not blown out for 5 to 15 min. or blown out not

warm wind for a moment at HEATING operation.

RUN light blinks slowly

(1.5 sec ON, 0.5 sec OFF)

When outdoor temperature is low and humidity is high, the

unit sometimes performs defrosting automatically. Please

wait. During defrosting, water or steam may escape from the

outdoor unit.

Airﬂ ow is not blown out when starting the DRY operation.

(RUN light is on)

The indoor fan may stop to prevent re-evaporation of

dehumiﬁ ed moisture and to save energy.

You hear a slight gurgling sound. This is caused by refrigerating liquid moving within the unit.

You hear a slight cracking sound. This is caused by heat expansion or contraction.

You hear a hissing or clicking sound. This is caused by the operation of the refrigerant control

valves or electric components.

Whistling noise is heard from the outdoor unit. The noise means that the revolution speed of the compressor

is increasing or decreasing.

Sometimes a “Shooooo” sound might come for a short

time from the unit that is turned off.

This is the sound when operation of another indoor unit is

stopped.

The unit does not restart immediately after you have

stopped it.

(RUN light is on)

Not

operating?

Restart is blocked for 3 minutes after you have stopped the

operation to protect the unit.

Please wait for

three minutes.

The three-minute protection timer in the microcomputer

automatically starts it up again.

Some steam escapes during COOL operation. This may occur if the room’s temperature and humidity are

very high. It disappears as soon as the temperature and

humidity decrease.

There is a slight smell. Air blown out during operation may smell. This is caused by

tobacco or cosmetics adhering to the unit.

After a power cut, the unit does not restart even if power

has been restored.

If the auto restart function is not set, the unit will not restart

automatically. Use the remote control to start the operation

again.

Remote control signals are not received. Remote control signals may not be received if the signal

receiver on the air-conditioner is exposed to direct sunlight or

other bright light.

If so, cut out the sunlight or reduce the other light.

Moisture may form on the air outlet grills. If the unit is operated for a long time in high humidity, moisture

may form on the air outlet grills and start dripping.

Fan will not stop immediately after unit operation was

stopped.

Indoor fan : Fan will not stop after 2 hours if set to CLEAN

operation.

Outdoor fan : Fan will not stop about a 1 minute period in

order to protect the unit.

RUN light stays on even though operation was stopped. The RUN light illuminates during CLEAN operation.

Run light turns off when CLEAN operation ends.

Air ﬂ ow

Noise

Others

RLD012A002G_EN.indd 29RLD012A002G_EN.indd 29 2015/02/27 14:36:442015/02/27 14:36:44

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Mitsubishi RLD012A002G Seite 30

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Mitsubishi RLD012A002G

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info