664855
140
Zoom out
Zoom in
Vorherige Seite
1/144
Nächste Seite
-
137
-
f) After charging liquid refrigerant into the air conditioner by closing the charging valve, stop operation by fully closing the
gauge manifold’s valve Lo. 2 5
g) Quickly remove the charge hose from the service port. 6
When stopped halfway, refrigerant being cycled will be released.
h) After securing the caps on the service port and control valve, check the caps’ periphery to see if there is any gas leakage. 6 7
Fig.7 Configuration of additional refrigerant charging
1
4
7
2
5
3
Opened
Electronic balance for refrigerant charging
Charging
valve
Refrigerant cylinder
(with syphon)
Service port
(Gas side)
(Liquid side)
Control valve
(2-way)
Opened
Service port 6
7
Control valve
(3-way)
(Indoor unit)
(Outdoor unit)
8.3.3 Removal (When using new refrigerant piping)
(1) Removing the unit
a) Recovery of refrigerant from the outdoor unit by pump down
At the time of pump down, use a gauge manifold exclusive for R410A.
Operating the unit in forced cooling mode, recover refrigerant from the outdoor unit.
(For details of reclaiming steps and precautions, see the instruction manual prepared by the equipment manufacturer)
* Caution:
In the case of an outdoor unit which is incapable of pump down, use a refrigerant recovery unit.
b) Removing the indoor/outdoor units
Remove the piping and wiring between the indoor and outdoor units.
•Tighten the outdoor unit’s control valves and service port with the specified torque.
•Tighten the capped flare nuts at the indoor/outdoor units connecting part with the specified torque.
Remove the indoor/outdoor units.
* Caution:
When storing the indoor unit piping in its original position, be careful not to break the piping.
(2) Installing the unit
a) Proceed with the installation following the steps described in “8.3.2 New installation work”.
8.3.4 Replacing the unit (Never use the existing refrigerant piping)
Use a brand-new refrigerant piping (1) when replacing the air conditioner using the conventional refrigerant (R22) with an air
conditioner using the alternative refrigerant (R410A) or (2) even when replacing the air conditioner using the alternative refrigerant
(R410A) with another air conditioner using R410A, as a problem may occur due to differences in pressure characteristics of refrig-
erant or differences in type of lubricating oil (air conditioners using R410A do not always use the same type of the lubricating oils).
8.3.5 Retrofitting
Do not operate the air conditioner which has used the conventional refrigerant (R22) by charging the alternative refrigerant (R410A).
Otherwise, the equipment may cease to function normally and go wrong, or even cause serious problems such as rupture of the
refrigeration cycle.
140

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Mitsubishi SKM22ZG-S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Mitsubishi SKM22ZG-S

Mitsubishi SKM22ZG-S Bedienungsanleitung - Deutsch - 24 seiten

Mitsubishi SKM22ZG-S Bedienungsanleitung - Holländisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info