4
GAS SAFETY (INSTALLATION AND USE) REGULATIONS 1998 (AS AMENDED)
It is the law that all gas appliances are installed by a registered person, in accordance with the above regu-
lations. Failure to install appliances correctly could lead to prosecution. It is in your own interest, and that of
safety, to ensure that the law is complied with.
Read these instructions carefully before attempting to operate the appliance. Comply with all applicable warn-
ings. Do not interfere with any sealed components, and use the appliance only in accordance with these
instructions.
INTRODUCTION
The Fagor FEB-24ED is wall hung, room sealed, fan assisted, microprocessor controlled, fully modulating
gas combination boiler for providing both central heating and domestic hot water.
DOMESTIC HOT WATER SERVICE
Turn the left knob (3) in order to turn the boiler on. The display will show "On" indicating that the boiler is ready
to supply Domestic Hot Water (DHW) whenever there is demand for it. When a hot tap is opened the boiler
automatically fires to deliver hot water and the orange light will come on indicating the burner is on. A water
temperature of between 35° and 60° C can be selected by turning the domestic hot water temperature regu-
lating knob. The value selected will be shown in the display when it is changed with the knob.
HOT WATER AND CENTRAL HEATING SERVICE
With the main control switch on and the display showing “On”,
turn the heating selector knob clockwise from the summer set-
ting.. The boiler will fire up automatically when either the time
clock/room stat or boiler stat calls for central heating, or a hot tap
is opened for hot water. If a hot tap is opened the boiler gives pri-
ority to hot water delivery with the central heating on standby
until the tap is closed.
The temperature of the radiators can be selected between 60ºC
and 85ºC by turning the right knob (2) the value will be shown on
the display.
Note: If the boiler has been configured for under floor heating the temperature cannot be altered by the user
operating the control knob. Only the pre-set value set up by the installer will be available
1.- USERS INSTRUCTIONS
