10
Auto clean function
Each time approximately 5L of water has been
used in the steam generator, it will need to run an
auto clean cycle. When the product is fully cooled
down and first switched on, it will draw water
from the water tank (15) to flush the boiler,
emptying dirty water and limescale into the dirty
water chamber (10). For this short time, the
descaling indicator light (25) will flash and you will
be unable to use the product to iron.
If there is not sufficient water to operate this
function, the product will alert you with the low
water level indicator light (30) and the process will
be paused until the tank is refilled and replaced.
WARNING: During the auto clean process, the
water ejected from the machine is very hot, so
do not remove the water tank until the auto
clean process is finished.
The auto clean process will take approximately 3
minutes, after which the steam generator will be
ready for normal operation again. The flashing
descaling indicator light (25) will extinguish and
the low steam level indicator light (27) will flash,
indicating that the steam generator is readying
itself for the low steam level setting.
After ironing, switch off the steam generator at
the On/Off power button (31) and unplug from the
mains outlet. If the auto clean function has
activated and completed, wait for the steam
generator to cool down completely. Remove the
detachable water tank and tip the dirty water from
the dirty water emptying holes (11).
IMPORTANT: Ensure the dirty water is emptied
after each auto clean cycle to prevent overflow.
WARNING: Dirty water in the dirty water
chamber
(10)
will be hot after the auto clean
process, so take care when pouring it out.
To clean a coated soleplate
Do not use scouring powder or solution as this
could cause damage to the coating.
If any man made fibres fuse to the soleplate (6),
set the iron at the MAX position and pass it over a
clean piece of cotton to draw the deposit off the
surface.
To clean the exterior
Allow the unit to cool and wipe over with a damp
cloth and mild detergent, then wipe dry.
Maintenance
