Bedienungsanleitung Morso 6612 (Seite 32 von 36) (Englisch, Dänisch)

744460

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Sprog

Reasons for overly rapid wear of internal parts

- Stove ﬁred too vigorously

Use of very dry wood (wood from old furniture)

- Too much soot on top of the bafﬂes (please see the section on Cleaning)

- Too much ash in the ash pan (please see the section on Ash)

Gaskets

The gaskets in the door will wear out over time, and should be replaced as required in order to

prevent runaway combustion. Use the original Morsø gasket kit.

NOTE: Normal wearing parts are not covered by Morsø’s extended warranty.

A selection of maintenance products (spare parts, glass cleaner, paint, gasket kit, etc.) is avail-

able from your Morsø dealer.

3.3 Cleaning the stove

A layer of ash and soot will form as a result of the draught in the chimney and after sweeping,

particularly on the top of the casted smoke hood. This ash will have an insulating effect, which

may speed up the burn-through of the bafﬂe.

During normal cleaning, the bafﬂe and the smoke hood can be removed from the stove. Once

these parts have been taken out, you can access the ﬂue chamber above the bafﬂe and clean

it.

Clean the bafﬂe and smoke hood before reassembling them, and make sure that they are cor-

rectly assembled.

Nowadays the chimney sweep must remove the soot in the stove, in addition to sweeping the

chimney and cleaning the ﬂue pipe.

The number of annual sweepings/cleanings of the stove should be determined in consultation

with your chimney sweep.

Ash

As noted above, there should be a couple of centimetres of linsulating ash in the bottom of the

combustion chamber in order to achieve a high combustion temperature. If the layer of ash is

too thick, it can be brushed down into the ash pan.

Empty the ash pan before it gets completely full, so that the ash does not insulate around the

grate, and thereby speed up the burn-through.

In most cases, the ash will need to be taken away by the waste disposal company. Because

embers may be concealed in the ash pan for several days, it may be necessary to store the ash

in a container made of non-ﬂammable material before pouring it into a rubbish bag.

waste. That will be a great beneﬁt to the environment.

Note: Should be handed in to a recycling station as ceramic glass.

Internal parts and/or wearing parts

The bafﬂes and other components that come in direct contact with the ﬁre and glowing fuel

are all wearing parts. As a result, they will be particularly susceptible to burn-through. When

used correctly, these parts will last for many years, but overly vigorous use will naturally ac-

celerate the burn-through. Such parts are all easily replaced.

If the bafﬂes are damaged and are not replaced in time, the top plate will be exposed to such

high temperatures that it may be damaged as well.

Please note that no unauthorised alterations of the design may be undertaken, and that any

parts that are replaced must be replaced with original Morsø parts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Morso 6612 Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Morso 6612

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info