745038
10
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
ENGLISH
Source Setup
Select and congure Source
1 Source: Select Source to congure
2 Name: Customize the Sources Name using the pop-up keyboard
3 Icon: Select and assign icon to the selected Source
4 Front View: Front display layout and contents can be congured
by selecting the following options – Album Only, Album and Text,
Source, Text Only and Analog VU meter. A combination of these
options is available depending upon the Source selected.
5 Auto Sense (applicable only for Optical Input, Coaxial Input
and HDMI Sources): Wake up from standby mode when triggered
by an active Optical Input, Coaxial Input or HDMI Source
6 Hide Source: Enable or disable selected Source
Music Library
1 Reindex Library: Scan for new les added to the Music Library
Other
1 Reboot: Cycle power by powering o and powering back the unit
2 Factory Reset: Restore to factory default settings
System Info
Display information about the following parameters
Show current or detected information about BluOS rmware
version, IP Address, MAC Address Ethernet and MAC Address
Wi-Fi.
Temperature Left/Temperature Right: If the internal temperature
of either left or right amplier channel reaches 91 degrees
centigrade, M10 will turn o automatically and a protect message
will be shown in the display. Once the temperature falls below
80 degrees centigrade, M10 will turn on again and the protect
message display will be cleared.
Bridge Mode: “On or “O is shown depending upon the setting
(ON/OFF) of the Bridge Mode switch at the rear panel.
AMP Protect/DC Error: If an internal fault is detected, Yes” is
shown in the display along with a message prompt instructing the
user to hard cycle the power of the M10 - this is required to clear
the error. “No” indicates the unit is operating as intended.
IDENTIFICATION OF CONTROLS
TOP AND FRONT VIEW
10
1
1
2
1
2
3
4
5
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für NAD M10 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von NAD M10

NAD M10 Bedienungsanleitung - Deutsch - 14 seiten

NAD M10 Bedienungsanleitung - Holländisch - 14 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info