Bedienungsanleitung Napoleon Triumph 325 SB (Seite 5 von 56) (Deutsch, Englisch, Französisch)

637888

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Technical Data

The following table lists input values for the appliance.

Burner Orice Siz

e (Gross) Heat Input (Total) Gas Usage (Total)

0.84mm (50mabr) 8.0 kw 580 g/hr

Side 0.92mm (30mbar) 3.5 kw 254 g/hr

Cered Gases / Pressures - Check rang plate to ensure that it corresponds with following list.

Do not tamper with or modify regulator. Use only regulator which supply the pressure listed in the table

above. A regulator of 28 – 30 mbar must be used for butane or a 37 mbar regulator for propane.

For replacement, use only the

manufacturer.

Gas Categ

3B/P(30)

3+(28-30/37)

3B/P(37)

3B/P(50)

Gases / Pre

ssur

But

ane 30mbar

Propane 30mbar

Butane 28-30mbar

Propane 37mbar

Butane

37mbar

Propane 37mbar

Butane 50mbar

Propane 50mbar

Countries BE, BG, CY, DK,

EE, FI, FR, GB,

HR, HU, IS, IT,

LT, LU, MT, NL,

NO, RO, SE, SI,

SK, TR

BE, CH, CY, CZ, ES,

FR, GB, GR, IE, IT,

LT, LU, LV, PT, SK, SI

PL AT, CH, DE, SK

Leak Tesng Ins

trucons

WARNING!

A leak test must be performed annually and each me a cylinder is hooked up or if a part

of the gas system is replaced.

WAR

NING!

Never use an open ame to check for gas leaks. Be certain no sparks or open ames are in

the area while you check for leaks. Sparks or open ames will result in a re or explosion, damage to prop-

erty, serious bodily injury, or death.

Leak tesng: This must be done before inial use, annually, and whenever any gas components are replaced

or serviced. Do not smoke while performing this test, and remove all sources of ignion. See Leak Tesng Dia-

gram for areas to check. Turn all burner controls to the o posion. Turn gas supply valve on.

Brush a half-and-half soluon of liquid soap and water onto all joints and connecons of the regulator, hose,

manifolds and valves.

Bubbles will indicate a gas leak. Either ghten the loose joint or have the part replaced with one recommend-

ed by the Napoleon Customer Care department and have the grill inspected by a cered gas installer.

If the leak cannot be stopped, immediately shut o the gas supply, disconnect it, and have the grill inspected

by a cered gas installer or dealer. Do not use the grill unl the leak has been corrected.

egula

or specied by the

www.napoleongrills.com

The regulator cannot be adjusted. There is a pressure tap located on the side of the regulator. It can

be used by a qualied service person when servicing the grill to determine if the regulator is funconing

properly. The screw within the pressure tap must always be kept ght, except when performing a pressure

test on the regulator (qualied service personnel only).

0.92mm (37mbar) 8.0 kw 580 g/hr

Main 0.99mm (30mbar) 8.0 kw 580 g/hr

0.86mm (37mbar) 3.5 kw 254 g/hr

0.80mm (50mabr) 3.5 kw 254 g/hr

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Napoleon Triumph 325 SB Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info