512547
13
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
SPEED 3100 log Installation and Operation Manual
NAVMAN
13
12 V DC
power
External beepers or
lights (optional)
Red
White
Green
Black
Yellow
Switch
Fuse
Orange
Blue
NavBus (optional)
Masthead
unit cable
NMEA out (optional)
NMEA in (GPS, optional)
}
Power/data cables
Junction box
Junction box
Power
& data
connections
Power/data cable
NavBus cable
Group 1
Group 2
Power & data
connections
Power/data wiring
1 Wire the display unit power/data cable:
The unit requires 12 V DC power. Fit a
power switch and fuse to the power supply
or power the unit from a fused auxiliary
switch. The fuse should be 1 A for up to five
instruments.
If the external beepers and lights require
more than 250 mA DC total, fit a relay.
A single unit can be wired as shown below:
With several instruments, use the optional
junction boxes to simplify wiring, as shown
below:
For information on how to connect NavBus and
to use junction boxes, refer to the NavBus
Installation and Operation Manual.
2 Tape or cover any unused wires or connectors
to protect them from water and keep them from
shorting together.
9-2 Set up
1 Take the boat for a trial run to check that all the
instruments work correctly.
2 If the unit will take speed readings from a GPS
receiver (rather than a speed transducer or an
external speed input from an instrument with a
speed transducer - see section 7):
i Press
+ several times until the Speed
Mode screen is displayed:
ii Press
or to change the mode to GPS
(when using a speed transducer, the mode
should be SEn).
iii Press
.
3 If the unit is part of a system of 3100 series
instruments connected by NavBus, set the
backlight group number (see section 7-1):
i Press
+ several times until the
Backlight Group screen is displayed:
ii Press
or to set the backlight group
number.
iii Press
.
4 Set:
Speed and log units (see section 3-1).
The speed resolution (see section 3-6).
The temperature units (see section 5-1).
5 Calibrate if required:
Speed (see section 3-7).
Temperature (see section 5-2).
Group 3
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Navman Speed 3100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Navman Speed 3100

Navman Speed 3100 Bedienungsanleitung - Deutsch - 16 seiten

Navman Speed 3100 Bedienungsanleitung - Holländisch - 16 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info