Bedienungsanleitung Nextbase 300W (Seite 43 von 46) (Englisch)

698620

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

TROUBLE SHOOTING

PROBLEM SOLUTION

The mount will not stay in place

upon my windscreen.

I cannot insert the MicroSD

card.

I cannot remove the MicroSD

card.

I can only record a few minutes

of video on my MicroSD card.

I cannot save files to the

memory card when the Dash

Cam is connected to my

computer under Mass Storage

mode.

No power to my Dash Cam, but

it works upon my PC.

My Dash Cam shuts down by

itself after a while.

I get the announcement

“Card Error. Please format

SD card”.

The SD card in my Dash Cam

cannot be read.

I can't delete files on my SD

card within the Dash Cam.

Ensure that the red protective cover (plastic film) has been removed

from the mount pad.

Make sure that the glass is smooth and clean.

Press the mount firmly to the glass ensuring that there is 100%

contact with the glass. This can easily be seen from outside the

windscreen, as contact area of the pad turns a darker colour.

If the mount pad has lost it's sticky qualities, change the pad for the

spare item contained within the box.

MicroSD card are very small and require delicate use. Align the card

with the diagram shown upon the Dash Cam and insert the card until

you feel a slight spring resistance. You now need to push the card,

using your finger nail, until you hear and feel a small latch. Release

pressure and the card will stay retained within the device. Use the

edge of a small coin if you have difficulty.

With the card previously installed, you now need to push the card

further inwards slightly, using your finger nail, until you hear and feel a

small latch.

Use the edge of a small coin if you have difficulty.

Release pressure and the card will spring out sufficiently for you to take

hold of it.

Replace the Class 10 type MicroSD card with a new quality branded

card. Max 128GB.

Ensure to format the new SD card from within the Dash Cam.

Correct, the Dash Cam is a 'read-only' device.

It is not recommenced to save files from other sources to the same

memory that you will use for recording within the Dash Cam, as these

may have a negative effect on the performance of the Dash Cam.

The cigarette power cable is not working. Inspect the fuse in the Car

Power plug. Replacement fuse = 2A 20mm type. If the fuse is found to

be blown, inspect the power cable for damage which may have caused

the fuse to blow.

Either there is no power to the Dash Cam or Parking Mode has been

turned on and no vehicle movement has been detected for 5 minutes.

The SD card has been formatted in another device and the Cluster

Size is not compatible. There may also be an error on the card.

Use the Setup option within the APP to re-format the SD card from

in the Dash Cam.

Ensure that the SD card is a Class10 type SD card of 8-128GB

Use a good quality branded SD card between 8GB and 128GB

Class 10 and format the card from within the Setup Menu of

the APP.

Check to see if these files are 'protected', if so please follow

instructions to 'un-protect' the files within the APP.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nextbase 300W Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info