Bedienungsanleitung Nextbase In-Car Cam 112 (Seite 33 von 36) (Englisch)

643621

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

TROUBLE SHOOTING (CONTD.)

My iN-CAR CAM shuts down

by itself after a while.

No power to my iN-CAR CAM,

but it works upon my PC.

The SD card in my

iN-CAR CAM cannot be read.

I can't delete files on my

SD card within the

iN-CAR CAM.

The screen blanks after a few

minutes upon my

iN-CAR CAM.

I get the message “Cluster

size wrong. Please format

SD card” on screen.

The battery will not charge.

The battery only last 30

seconds.

The battery only lasts 20

minutes.

I get the message “Card Error”

on screen.

I get the message “Card Full”

on screen.

The AV Out from my

iN-CAR CAM just buzzes on

my TV.

When I press the MENU

button nothing happens.

PROBLEM SOLUTION

Either the battery has gone flat, or there is no power to the

iN-CAR CAM and the AutoPower Off period has been triggered.

The cigarette power cable is not working. Inspect the fuse in the

Car Power plug. Replacement fuse = 2A 20mm type. If the fuse is

found to be blown, inspect the power cable for damage which may

have caused the fuse blow.

Use a good quality branded SD card between 8GB and 32GB

(Class 10 or UHS type 1) and format the card from within the

Setup menu.

Check to see if these files are 'protected', if so please follow

instructions to 'un-protect'.

The Screen Saver function is set to ON. Change settings to OFF if

required. Default setting is off.

The SD card has been formatted in another device and the

Cluster Size is not compatible. Use the Setup option to re-format

the SD card from within the iN-CAR CAM.

Ensure the iN-CAR CAM is connected to a reliable power source

and that the supplied Car Power Cable is being used, with the

Green LED lit.

The battery will only receive charge when the iN-CAR CAM is

connected to power, please reconnect the car adaptor and leave

the iN-CAR CAM turned on.

Charging takes approximately 90 minutes and a full charge is

indicated when the BLUE (charging) LED goes out.

This is normal, the battery design allows the 'Auto Power Off'

feature to function in event of power loss within the vehicle.

It is not intended as an alternative power source to replace the

supplied car adaptor.

The SD card has become unusable by the iN-CAR CAM.

Remove useful files using your PC and then perform a “FORMAT”

upon the SD card from within iN-CAR CAM the Setup Menu.

The SD card has become full as there may be too many protected

files which will not be deleted to allow for further recording to take

place. Delete unnecessary files or perform a full FORMAT upon the

SD card from within the iN-CAR CAM Setup Menu.

Ensure that the AV cable is correct. Use a stereo 2.5mm jack plug

where the tip is the video and the ring is the audio signal.

Please visit: nextbaseshop.co.uk to purchase the correct AV Cable.

This is normal during recording. Stop the recording before

pressing the MENU button.

If recording re-starts before you can press MENU, then see

the Parking Mode section above.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Nextbase In-Car Cam 112 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Nextbase In-Car Cam 112

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info