Bedienungsanleitung Niko 100-78010 (Seite 10 von 12) (Deutsch, Englisch, Holländisch, Französisch)

619208

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

1XX-7801X

SK nv Niko sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: support@niko.be — www.niko.eu PM1XX-7801XR13375

Automatic and unwanted

switching

The motion detector switches on

after the mains voltage has been

interrupted.

The lighting is illuminated for

90 seconds before the

interruption. After that, the device

is in automatic mode.

Sunlight falls on the lens or in the

detection area.

Set the lux value to twilight.

Heat/cold penetrates through to

the detection area by way of an

open door or window.

Close the door or window or

move the device.

6. TECHNICAL DATA

dimensions

base: 31 mm (D)

motion detector: 30 mm (D)

power supply voltage 230 Vac ± 10%

mounting ﬂush-mounting box with ﬂush-mounting depth of min.

40 mm

connection terminals 5 (maximum capacity per connection terminal:

1 x 2.5 mm²)

no-load power consumption < 0.5 W

relay contact max. 10 A, 250 Vac, light- and motion-sensitive

maximum switching capacity 140 µF

maximum switching current 165 A/20 ms

detection angle

horizontal: 180° – vertical: 60°

(see illustrations below)

detection range 8 – 9 m

switch-off delay ± 1 – 30 min

light sensitivity ± 10 – 1000 lux

mounting height 0.8 – 1.2 m

ambient temperature -5 – +45°C

protection degree IP40

functionality may be used as master or as slave

8-9 m 8-9 m0

180°

0°

50°

10°

0 m

0.8 - 1.2

7. WARNINGS REGARDING INSTALLATION

- The installation should be carried out by a registered installer and in compliance with the statutory regulations.

- This manual should be presented to the user. It should be included in the electrical installation file, and it

should be passed on to any new owners. Additional copies are available on the Niko website or via the Niko

support service. The latest manual for this product is available on the Niko website at any time.

- During installation, the following should be taken into account (non-exhaustive list):

- the statutory laws, standards and regulations.

- the technology currently available at the time of installation.

- this manual, which only states general regulations and should therefore be read within the scope of

each specific installation.

- the rules of proper workmanship.

This product complies with all of the relevant European guidelines and regulations. If applicable, you can find

the EC declaration of conformity regarding this product at www.niko.eu.

8. NIKO SUPPORT

In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support

service in Belgium at +32 3 778 90 80 or your wholesaler/installer. Contact details and more information can

be found at www.niko.eu under the “Help and advice” section.

9. GUARANTEE PROVISIONS

- The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of purchase

of the product by the consumer. If there is no invoice, the date of production applies.

- The consumer is obliged to inform Niko in writing about the non-conformity, within two months after stating

the defect.

- In case of a non-conformity, the consumer only has the right to a product repair or replacement free of charge,

which shall be decided by Niko.

- Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or careless

use, incorrect operation, transformation of the product, maintenance that does not adhere to the maintenance

instructions or an external cause, such as damage due to moisture or overvoltage.

- The compulsory regulations of the national legislation concerning the sale of consumer goods and the

protection of the consumer in the countries where Niko sells, directly or via sister companies, subsidiaries,

chain stores, distributors, agents or permanent sales representatives, take priority over the above-mentioned

rules and regulations.

Pred inštaláciou a spustením systému si prečítajte celý návod. Návod uschovajte pre budúce použitie.

1. POPIS

180° detektor pohybu so zapustenou montážou je elektronický spínač detekcie pohybu, ktorý je určený

len na použitie v interiéri. Detektor pohybu zapne záťaž (osvetlenie), ak sa zistí pohyb zdroja tepla a ak je

intenzita denného svetla nižšia ako nastavená hodnota luxov. Zariadenie deteguje pohyb pomocou pasívneho

infračerveného snímača (PIR).

Zariadenie (aktivátor + snímač) je dodávané na predmontovanom kovovom prístrojovom spodku (45 x 45).

Rámček je potrebné objednať samostatne.

2. INŠTALÁCIA

2.1. Zapojenie

Nebezpečenstvo: Pred inštaláciou detektora pohybu odpojte všetky zdroje energie. Nepripájajte zariadenie k

napájaciemu zdroju až do dokončenia inštalácie (vrátane rámčeka).

A. Jeden svetelný okruh s jedným detekčným bodom

Pripojte detektor pohybu a záťaž podľa nasledujúcej schémy:

230 Vac

B. Jeden svetelný okruh s viacerými detekčnými bodmi

V tomto prípade musí byť priradený master a slave. K jednému detektoru master môžete priradiť najviac

osem detektorov slave.

Pripojte slave k master podľa schémy nižšie:

230 Vac

Slave Master

C. Použitie externého tlačidla alebo spínača

Ak sa má dať zariadenie ovládať aj ručne, k detektoru pohybu pripojte externé tlačidlo alebo spínač. Tlačidlo

alebo spínač môžete pripojiť buď k master alebo slave.

Pre pripojenie tlačidla alebo spínača postupujte podľa nižšie uvedenej schémy:

230 Vac

2.2. Montáž

Tip: Neinštalujte detektor pohybu na plochu s priamym slnečným svetlom ani v blízkosti zdrojov tepla alebo

vzdušných prúdov (ventilácia alebo klimatizácia). Môže to zbytočne aktivovať detektor pohybu.

Tip: Namontujte detektor pohybu (master) na miesto, kde sa dá intenzita svetla čo najlepšie merať (hodnota v luxoch).

Pripevnite detektor pohybu do montážnej krabice s hĺbkou zapustenia 40 mm vo výške od 0,8 do 1,2 m.

3. NASTAVENIA

Pod odklápacím krytom na prednej strane detektora pohybu sú dva potenciometre na nastavenie nasledovných

štyri parametrov:

svetelná citlivosť (± 10 – 1000 lux)

doba oneskorenia vypnutia (± 1 – 30 min.)

slave

testovací režim

3 4

Niko 100-78010 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info