609460
91
Zoom out
Zoom in
Vorherige Seite
1/124
Nächste Seite
USER MANUAL
ENGLISH
9098960000(1)2011-04 A SCRUBTEC R 466 - R 471 - R 471C - BOOST
®
R4 29
TROUBLESHOOTING
TROUBLE POSSIBLE CAUSE REMEDY
The motors do not work; no warning light turns on.
The battery connector is disconnected. Connect.
The batteries are discharged. Charge the batteries.
The machine does not move and the display (71)
shows the error code:
The machine has been turned on by using the
ignition key and by keeping the pedal pressed.
Release the drive pedal.
If the problem persists, contact an authorised
Service Center.
At the machine start-up, the LED (64) of the
switch (63) ashes and the brushes do not work.
The machine has been turned off without
lifting the brush deck.
Wait for the deck to lift before turning on again
the brushes by pressing the switch.
The brushes do not work; the red warning light
ashes.
The batteries are discharged. Charge the batteries.
The 3 warning lights (62) ash simultaneously.
The brush motors are overloaded.
Use less aggressive brushes and/or avoid
working with extra pressure turned on.
There are foreign materials (tangled threads,
etc.) preventing the brushes from rotating.
Clean the brush hubs.
The display (71) shows an error code as:
where “00” is replaced by a code different from
“t4”.
The machine electronic control system is in
alarm condition.
Turn off the machine and then turn it on again.
If the problem persists, contact an authorised
Service Center.
The dirty water vacuuming is insuf cient.
The recovery tank is full. Empty the tank.
The vacuum grid is clogged or the oat is
closing.
Clean the vacuum grid.
The container with debris collection grid is
clogged.
Clean.
The hose is disconnected from the squeegee. Connect.
The squeegee is dirty, or the squeegee blades
are worn or damaged.
Clean the squeegee or overturn/replace the
blades.
The tank cover is not properly closed, or the
gasket is damaged.
Correctly close the cover or clean/replace the
gasket.
The solution ow is insuf cient.
The solution tank is empty. Re ll.
The solution lter is dirty. Clean the lter.
The Chemical Mixing System tank (optional)
is dirty/clogged.
Clean with the drain cycle.
The squeegee leaves marks on the oor.
There are debris under the squeegee blades. Remove the debris.
The squeegee blades are worn, chipped or
torn.
Overturn or replace the blades.
The squeegee is not balanced with the
handwheel.
Adjust the squeegee.
NOTE
If the machine has a battery charger installed, the machine cannot operate if the charger is not on board. In case of
battery charger malfunction, contact an authorised Service Center.
For further information, contact Nil sk Alto Service Centers.
9098960000(1)2011-04 A.indb 299098960000(1)2011-04 A.indb 29 07/04/2011 15:59:2307/04/2011 15:59:23
91

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Nilfisk-ALTO SCRUBTEC R 466 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info