709179
3
Zoom out
Zoom in
Vorherige Seite
1/4
Nächste Seite
3
Photocell User Manual P5102
I. Technical Specification
1. Working voltage: 12~24VAC/DC
2. Working current (24VDC): emitter: 15mA receiver: 30mA
3. Photocell wavelength: 940nm
4. Angle of opposite emission: ± 5º
5. Receiver range: 12m
6. Internal rotation system adjusted angle: 0180 º
7. Working temperature: -20º +60
8. Relay contact loading capacity: 1A/30VDC
9. Waterproof grade: IP54
10. Size: 127x50x28mm
II. Safety Instruction
1. For security, please read the user manual carefully before initial operation;
2. Please be sure the power is off before connecting, the product is produced without fuse;
3. It is used only for the manual remote control and wireless control equipment / system, this system must not
endanger life or property during the running failure or its security risks have been eliminated;
4. Please operate the product in effective receive range.
III. Picture Display
IV. Installation Instruction
1. The product should be installed more than 20cm upper the ground (to avoid reflection), and the distance between
emitter and receiver shall be more than 0.5 meters (if not, maybe the photocell will be working on or cannot work);
2. the end user should install the photocell on the back of the direct sunshine or other strong shining (± 5º) to keep the
photocell work well steadily
3. Please try to avoid installing other photocell emitters within effective receive range;
4. If you should install many photocells on the same line, you can install receivers on two ends and then emitters in the
middle back to back which can effectively avoid the above-mentioned problem.
5. In order to avoid signal bias of emitters and receivers, which will easily cause misoperation, please install the
photocell firmly.
6. Connecting power after checking no error of connecting lines:
emitter LED lights, receiver LED lights, receiver NO/COM connects while NC/COM disconnects;
Making the CAP of emitter and receiver align, receiver LED off, NC/COM connects while NO/COM disconnects. If
the signal between emitter and receiver is interrupted, receiver LED lights, NC/COM disconnects while NO/COM
connects.
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Novoferm P5102 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info