589439
2
Zoom out
Zoom in
Vorherige Seite
1/5
Nächste Seite
Instructions manual :
In normal mode :
1) The 3 values displayed are actual windspeed, humidity and temperature.
2) Hold down the left push button for more than 2 seconds to switch the units
(km/h, mph, knots, m/s and fps)
3) Hold down the right push button to switch from °C to °F.
Temperature and humidity measurements are updated every 16 seconds) each
second for the wind) but you can force a measure by pressing the adjust button. If a
value exceeds the alarm level, the buzzer will beep for 15 seconds.
If a value reaches any of the 3 alarms levels (wind / humidity / temperature), the
corresponding alarm will turn on (the corresponding led is flashing and the buzzer
beeps 1 beep of ½ second for a low level alarm 2 beeps of a ¼ second for a high
level alarm.
To turn the alarms on or off, hold down for 2 seconds the push buttons + and -. The
flag >ALARM< is displayed when the alarms are on.
Setting mode :
Push the “adj” push button for 2 seconds to activate the set up mode. Then you can
set the alarm levels value (min and max for temperature and humidity and “lo” and
“hi” for the wind) by pushing the “+” or “-“ buttons.
Push the “adj” push button to switch from an alarm to the other one. Hold it down of
more than 2 seconds to come back in the normal mode.
Limited warranty :
This limited warranty shall be in effect for one year after the date of purchase by the original consumer
purchaser. During this limited warranty period, JDC ELECTRONIC SA will repair or replace without
charges any defective product with a comparable product. This limited warranty will not apply to any
instrument that has been misused, improperly installed, repaired, altered or which has been the
subject of any negligence or accident.
JDC ELECTRONIC SA
Uttins 40, CH-1400 YVERDON, SWITZERLAND
Phone ++41 (24) 445 2121 Fax ++41 (24) 445 2123
info@jdc.ch www.jdc.ch
…SWISS PRECISION INSTRUMENTS
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für NTech SKYWATCH AWS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info