Bedienungsanleitung Numark Im1 (Seite 5 von 20) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

618172

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

REAR PANEL FEATURES

1. AC IN – Use the included power adapter to connect the

mixer to a power outlet. While the power is switched off,

plug the power supply into the mixer first, then plug the

power supply into a power outlet.

Note: The mixer is designed to work with the included

power supply only. Using an incompatible power supply

could result in damage to the unit.

2. MASTER OUTPUT (RCA) – Use standard RCA cables

to connect this output to a speaker or amplifier system.

The level of this output is controlled by the MASTER

knob on the top panel.

3. LINE INPUTS (RCA) – Connect line-level devices, such

as CD players, samplers or audio interfaces, to these

inputs.

4. PHONO INPUTS (RCA) – Connect phono-level devices, such as turntables, to these inputs.

5. GROUNDING TERMINAL – If you are using phono-level turntables with a grounding wire, connect the grounding wire to

these terminals. If you experience a low “hum” or “buzz”, this could mean that your turntables are not grounded.

Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be

connected to the grounding terminal.

TOP PANEL FEATURES

1. POWER LED – Illuminates when the mixer is on.

2. MASTER – This control adjusts the output volume of the

Program mix.

3. MIC GAIN – Adjusts the audio level of the microphone

signal.

4. CUE GAIN – Adjusts the level of the headphone audio.

5. CUE SLIDER – Slide this to mix between Channels 1

and 2 in the headphones. When all the way to the left,

only Channel 1 will be heard. When all the way right,

only Channel 2 will be heard.

6. CHANNEL GAIN – Adjusts the corresponding channel’s

pre-fader and pre-EQ gain level.

7. CHANNEL TREBLE – Adjusts the high (treble)

frequencies of the audio on the corresponding channel.

8. CHANNEL BASS – Adjusts the low (bass) frequencies

of the audio on the corresponding channel.

9. INPUT SELECTOR – Selects the input source to be

routed to the corresponding channel. Input jacks are

located on the rear panel.

10. CHANNEL FADER – Adjusts the audio level on the

corresponding channel.

11. CROSSFADER – Blends audio playing between

Channels 1 and 2. Sliding this to the left plays channel

1 and sliding to the right plays Channel 2.

Note: The crossfader is user-replaceable if it should

ever wear out. Simply remove the facepanel, then

remove the screws holding it in position. Replace the

fader with a quality authorized replacement from your

local Numark retailer only.

12. MIC INPUT – Connect ¼” microphones to this input.

The microphone controls are located on the top panel.

13. HEADPHONES – Connect your ¼” headphones to this

output for cueing and mix monitoring.

14. DOCK * – Connect your iPod here. Gently rock the

iPod back and forth over the connector when attaching

or removing it.

15. DOCK ADJUSTER – Turn this knob accordingly so

your docked iPod rests against the support.

234

1010

12 13

* To record the Program mix to an iPod:

1. Connect the iPod to the DOCK.

2. In the iPod, go to Extras  Voice Memos and select

Record Now.

3. When you are finished recording, stop and save it.

Note: You cannot play a track from the iPod and record to

it at the same time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Numark Im1 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info