618167
4
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
4
REAR PANEL FEATURES
1. POWER SWITCH – Turns the mixer on and off.
Turn on the mixer after all input devices have been
connected and before you turn on amplifiers. Turn
off amplifiers before you turn off the mixer.
2. AC IN – Use the included power adapter to
connect the mixer to a power outlet. While the
power is switched off, plug the power supply into
the mixer first, then plug the power supply into a
power outlet.
Note: The mixer is designed to work with the
included power supply only. Using an incompatible
power supply could result in damage to the unit.
3. MASTER OUTPUT (RCA) Use standard RCA cables to connect this output to a speaker or amplifier system. The
level of this output is controlled by the MASTER knob on the top panel.
4. LINE INPUTS (RCA) Connect line-level devices, such as CD players, samplers or audio interfaces, to these inputs.
5. PHONO INPUTS (RCA) – Connect phono-level devices, such as turntables, to these inputs.
6. GROUNDING TERMINAL – If you are using phono-level turntables with a grounding wire, connect the grounding wire to
these terminals. If you experience a low “hum” or “buzz”, this could mean that your turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be
connected to the grounding terminal.
TOP PANEL FEATURES
1. POWER LED – Illuminates when the mixer is on.
2. STEREO LEVEL INDICATOR – Displays the audio
level of the Program mix.
3. MASTER – This control adjusts the output volume of the
Program mix.
4. MIC GAIN – Adjusts the audio level of the microphone
signal.
5. MIC TREBLE – Adjusts the high (treble) frequencies of
the microphone channel.
Tip: If you experience feedback when using a
microphone at loud levels, try turning down the high
frequencies.
6. MIC BASS – Adjusts the low (bass) frequencies of the
microphone channel.
7. CUE GAIN – Adjusts the level of the headphone audio.
8. CUE MIX – Turn to mix between Channels 1 and 2 in
the headphones. When all the way to the left, only
Channel 1 will be heard. When all the way right, only
Channel 2 will be heard.
9. CHANNEL GAIN – Adjusts the corresponding channel’s
pre-fader and pre-EQ gain level.
10. CHANNEL TREBLE – Adjusts the high (treble)
frequencies of the audio on the corresponding channel.
11. CHANNEL BASS – Adjusts the low (bass) frequencies
of the audio on the corresponding channel.
12. INPUT SELECTOR – Selects the input source to be routed to the corresponding channel. Input jacks are located on the
rear panel.
13. CHANNEL FADER – Adjusts the audio level on the corresponding channel.
14. CROSSFADER – Blends audio playing between Channels 1 and 2. Sliding this to the left plays channel 1 and sliding to
the right plays Channel 2.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then remove the
screws holding it in position. Replace the fader with a quality authorized replacement from your local Numark retailer
only.
15. MIC INPUT – Connect ¼” microphones to this input. The microphone controls are located on the top panel.
16. HEADPHONES – Connect your ¼” headphones to this output for cueing and mix monitoring.
1
6
2
3
3
4
4
4
4
5
5
5
5
1
2
14
15 16
3
49
10
11
12 12
13
13
10
11
9
5
6
7
8
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Numark M101 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info