Bedienungsanleitung Oce OP25 Operation Guide Printing System Set-up (Seite 15 von 20) (Englisch)

47540

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

3. Troubleshooting

3-2 When an error message appears…

If an error message appears on the operation panel, first check the following tables for cause of the trouble and then perform the corresponding

procedure. For more detailed information, refer to the Operation Guide for your copier as well as the Operation Guide for any optional equipment

that is installed in your machine.

Display message

Add paper in drawer.

XX size (XXX)

Use alternative? Press GO

Set paper Press GO

Place paper in drawer.

PLACE PAPER IN PAPER DRAWER.

Add staples.

Call service.

Department code mismatch

Exceeded print quantity limit.

Exceeded pre-registered printing quantity.

Error in printer mode

RAM Disk error Press GO

Procedure

The size or type of paper selected for printing does not match the size or type of paper in the

drawer. Replace the paper in the drawer with that of the correct size and type.

• If you want to switch to and print from a different drawer, select the desired drawer on the

touch panel and then touch the “GO” key.

• The following commands will be displayed in the printer mode.

GO: Force-prints onto the current size or type of paper.

Cancel: Cancels the printing operation completely.

Displayed after changing the drawer. Touch the “GO” key.

This mode feeds a stack of multiple sheets one at a time. Every time you want to feed a

sheet, touch the “GO” key.

The drawer has run out of paper. Add paper.

The finisher (option) has run out of staples. Refer to the Operation Guide for the finisher and

replenish the staples.

Trouble has occurred within the printer. Contact your service representative or an authorized

service center.

The department code you entered does not match the registered one. Check the department

code that is registered in the printer driver.

The amount of printing accomplished has exceeded the acceptable capacity as set under

copy management. In order to print further, change the copy management setting in the

printer.

This message will appear when a printer error occurs and the machine is in a mode other

than the printer mode. Press the Printer key to switch to the print mode screen and the

corresponding error message will be displayed.

Code:##

Check the error code displayed in place of ## and refer to the following.

01: Format error. Turn power OFF and ON again.

02: The RAM disk mode is OFF. Turn it ON.

03: A write error has occurred. Turn OFF write protection.

04: The RAM disk does not have enough area to store the data. Delete any unnecessary

data to make more room.

05: The selected file could not be found. Check the file name and whether it is on the RAM

disk or not.

06: There is not enough system memory. Increase memory capacity.

98: Some of the data being collated was not read. Job data is corrupt.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Oce OP25 Operation Guide Printing System Set-up Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info