Bedienungsanleitung Olympia Fires Muria (Seite 6 von 9) (Englisch)

694433

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

Objects made of combustible materials mst not be placed onto the appliance or in a distance

smaller than the safety distance from the appliance.

4.2 Measures in the event of fire in the chimney

During normal operation, especially if damp fuel is used, soot and tar build up in the chimney. If

the chimney is not regularly checked and cleaned, danger of fire in the chimney will increase.

If this happens, proceed as follows:

 do not, under any circumstances, extinguish with water

 close all air inlets for combustion, if possible cover up the chimney

 contact a chimney service to examine the chimney condition after the fire

 contact the manufacturer to check the appliance

If combustible vapours or gases originate, there is a fire or explosion hazard; the stove must be

taken out of service (put out, remove ashes) and proper ventilation must be ensured.

5. First firing

Before and during the first firing leave the stove and ashpan doors slightly open (ca. 1-2 mm) so

that the sealing material does not amalgamate with the varnish. The varnish will harden as late as

after a few hours of firing. Check how the fireclay plates are settled in the combustion chamber

before making the first fire. Keep the temperature rather low during the first firing (feed the fire

more often with smaller amounts of fuel). All materials must adapt to heat development and the

hearth lining will dry slowly. The stove varnish will harden, which will be accompanied by

temporary odour; this odour will later entirely disappear. This provides that no microcracks,

varnish damage or material warping will occur. If the stove is lined with tiles, a fine microcrack

structure will appear on the tiles. This is not a defect; it is a natural accompaniment of heat stress

of the glaze. Sounds ocuring during the heating up or cooling of the stove do not signalize any

defect either.

During the hardening of varnish, sufficient room ventilation must be ensured and pets or birds

must not stay in the room where varnish vapours are present.

5.1 Fire lighting

Insert some crumpled paper into the combustion chamber and put small pieces of wood on it.

Lighting the fire is very easy with a solid firelighter. After lighting, leave the fire to flare up freely

with both the primary and the secondary inlets open. It is prohibited to use flammable liquids (such

as benzine, paraffin oil, etc.) for lighting the fire. As soon as the fire starts to burn and the draught

is sufficient, bigger logs or briquettes can be inserted without fear of excessive smoke. The

combustion air will enter to the fuel from below through the grate. Insert maximum the given

amount of fuel depending on the rated stove output. Fuel consumption is given in the respective

technical data tables. Burning intensity can be regulated by means of the primary air control

elements or by reducing the chimney draught, if there is a smoke flap installed. Bigger amounts of

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Olympia Fires Muria Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info