504943
7
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
English
6
R5-I
If a measuring error has occurred, this is indicated by or .Please refer to
the instructions.
When you press the ON/OFF (O/I) but-
ton, all the symbols on the display
light
up briefly. This serves to check the dis-
play. Then all the symbols go out and
the air release symbol
( ) begins to
flash. When the symbol (
)
appears,
the monitor is ready and begins the
measurement.
SYS
mmHg
DIA
mmHg
PULSE/min
Your blood pressure is measured during
inflation, so it is important not to move.
Sit still and do not move your wrist! Do
not talk! Do not touch the monitor while
it is measuring.
The monitor inflates the cuff and the
measurement is taken within approx.
30 seconds.
Once the arrow appears in the display the
measurement is finished and deflation of
the cuff takes place.
After this the systolic and diastolic blood
pressure is shown, alternating with the
pulse reading. This reading will be stored
in the memory.
Display of pulse rate
Alternating
display
Display of measurement results
Measurement of blood pressure is now complete. Press the O/I button to
turn power off.
Should you forget to turn off the power, it will turn itself off automatically after
2 minutes. The previous reading will remain in the memory even if the batteries
run down or are replaced.
E
E
E
I
If you wish to repeat the measurement, you should remove the cuff for at least
3 minutes because if you take the next measurement immediately, a slight blood
congestion may occur wich can lead to incorrect measurements or an error
message.
Keep a record of your measurements. In this way both you and your doctor will
have an accurate overview of your blood pressure situation.
Wrist blood pressure is measured at the different region from the usual brachial
blood pressure measurement and may show slightly different value. In many
cases, the difference between the wrist and the brachial blood pressures can be
up to –10 mmHg both for the systolic and the diastolic pressures for the healthy
people.
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

omron-r5-i---hem-630-e

Suche zurücksetzen

  • Bedienungsanleitung auf Deutsch - wo finde ich sie ?



    Eingereicht am 2-4-2019 13:45

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Omron R5 I - HEM-630-E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info