Bedienungsanleitung Onkyo cr 505 (Seite 3 von 40) (Englisch)

159239

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Precautions

Recording Copyright

Unless it’s for personal use only, recording copyrighted

material is illegal without the permission of the copy-

right holder.

AC Fuse

The AC fuse inside the CR-505DAB is not user-service-

able. If you cannot turn on the CR-505DAB, contact

your Onkyo dealer.

Care

Occasionally you should dust the CR-505DAB all over

with a soft cloth. For stubborn stains, use a soft cloth

dampened with a weak solution of mild detergent and

water. Dry the CR-505DAB immediately afterwards

with a clean cloth. Don’t use abrasive cloths, thinners,

alcohol, or other chemical solvents, because they may

damage the ﬁnish or remove the panel lettering.

Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE

FIRST TIME, READ THE FOLLOWING SECTION

CAREFULLY.

AC outlet voltages vary from country to country. Make

sure that the voltage in your area meets the voltage

requirements printed on the CR-505DAB’s rear panel

(AC 230 -240 V, 50 Hz).

Setting the [STANDBY/ON] switch to STANDBY does

not fully shutdown the CR-505DAB. If you do not

intend to use the CR-505DAB for an extended period,

remove the power cord from the AC outlet.

Never Touch This Unit

with Wet Hands

Never handle this unit or its power cord while your

hands are wet or damp. If water or any other liquid gets

inside this unit, have it checked by your Onkyo dealer.

Installing This Unit

• Install this unit in a well-ventilated location.

• Ensure that there’s adequate ventilation all around

this unit, especially if it’s installed in an audio rack. If

the ventilation is inadequate, the unit may overheat,

leading to malfunction.

• Do not expose this unit to direct sunlight or heat

sources, because its internal temperature may rise,

shortening the life of the optical pickup.

• Avoid damp and dusty places, and places subject to

vibrations from loudspeakers. Never put the unit on

top of, or directly above, a loudspeaker.

• Install this unit horizontally. Never use it on its side

or on a sloping surface, because it may cause a mal-

function.

• If you install this unit near a TV, radio, or VCR, the

sound quality may be affected. If this occurs, move

this unit away from the TV, radio, or VCR.

Moisture Condensation

Moisture condensation may damage this unit.

Read the following carefully:

When you take a glass containing a cold drink outside

on a summer’s day, drops of water, called condensation,

form on the outside of the glass. Similarly, moisture

may condense on the lens of the optical pickup, one of

the most important parts inside this unit.

• Moisture condensation can occur in the following sit-

uations:

— The unit is moved from a cold place to a warm

place.

— A heater is turned on, or cold air from an air con-

ditioner is hitting the unit.

— In the summer, when this unit is moved from an

air conditioned room to a hot and humid place.

— The unit is used in a humid place.

• Do not use this unit when there’s the possibility of

moisture condensation occurring. Doing so may

damage your discs and certain parts inside this unit.

If condensation does occur, remove all discs and leave

this unit turned on for two to three hours. By this time,

the unit will have warmed up and any condensation will

have evaporated. To reduce the risk of condensation,

keep this unit connected to a wall outlet.

For British models

Replacement and mounting of an AC plug on the power

supply cord of this unit should be performed only by quali-

ﬁed service personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance with

the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this appara-

tus may not correspond with the coloured markings identi-

fying the terminals in your plug, proceed as follows:

The wire that is coloured blue must be connected to the ter-

minal that is marked with the letter N or coloured black.

The wire that is coloured brown must be connected to the

terminal that is marked with the letter L or coloured red.

IMPORTANT

A 3, 5 or 13 ampere fuse is ﬁtted in this plug. Should the

fuse need to be replaced, please ensure that the replacement

fuse has a rating of 3, 5 or 13 amperes and that it is approved

by ASTA or BSI to BS1362. Check for the ASTA mark or

the BSI mark on the body of the fuse.

IF THE FITTED MOULDED PLUG IS UNSUITABLE

FOR THE SOCKET OUTLET IN YOUR HOME THEN

THE FUSE SHOULD BE REMOVED AND THE PLUG

CUT OFF AND DISPOSED OF SAFELY. THERE IS A

DANGER OF SEVERE ELECTRICAL SHOCK IF THE

CUT OFF PLUG IS INSERTED INTO ANY 13 AMPERE

SOCKET.

If in any doubt, consult a qualiﬁed electrician.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo cr 505 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info