462139
12
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
12
While the OSD mode is set to On, you can set
the RI Dock’s video output to PAL or NTSC.
If the onscreen display looks distorted on your
TV, try changing the TV system.
While pressing and holding down the
[SETUP] button, press the VOLUME Up [ ]
button for more than 3 seconds to select
NTSC, or press the VOLUME Down [ ] but-
ton for more than 3 seconds to select PAL.
Functions
Depending on your amp and generation of
iPod/iPhone, you may also be able to use the
following functions.
•System On Function
When you turn on your amp, the iPod/iPhone
turns on as well. With some amps, you may
need to press the [ON] button on your amps
remote controllers twice to turn on the other
components in your system.
System Off Function
When you turn off your amp, the iPod/iPhone
turns off as well.
Auto Power On Function
*
If you start iPod/iPhone playback while your
amp is on Standby, your amp will automatically
turn on and select your iPod/iPhone as the
input source. Then, your iPod/iPhone will start
playback.
Direct Change Function
*
If you start iPod/iPhone playback while listen-
ing to another input source, your amp will
automatically select your iPod/iPhone as the
input source.
•Timer Play
You can use your amps Timer function to turn
on your amp and iPod/iPhone and start play-
back at a specified time.
Using Your Amps Remote Controller
You can use your amps remote controller to
control basic iPod/iPhone functions (see
page 14).
Setting the TV System
(European model only)
Other Functions
* If you use your iPod/iPhone model’s controls to start an
iPod/iPhone slideshow or video, these functions will not work,
so use the remote controller instead.
Note:
Your amp may take several seconds to
startup, so you might not hear the first
few seconds of the first song/video.
Operating Notes:
The RI Dock must be connected to your
amp with both an cable and an audio
cable to use the functions.
If your amp doesnt support the System
On, System Off, Auto Power On, and
Direct Change functions, you’ll need to
turn your amp on and off and select the
input source manually.
Before you select another input source,
stop iPod/iPhone playback to prevent
your amp from selecting the iPod/iPhone
input source by mistake.
If any accessories are connected to your
iPod/iPhone, your amp may not be able
to select the input source properly.
While your iPod/iPhone is in the RI Dock,
its volume control has no effect. If you
adjust your iPod/iPhone model’s volume
control while it’s in the RI Dock, make sure
it’s not set too high before you reconnect
your headphones.
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo DS-A4 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Onkyo DS-A4

Onkyo DS-A4 Bedienungsanleitung - Deutsch, Holländisch - 60 seiten

Onkyo DS-A4 Bedienungsanleitung - Französisch - 32 seiten

Onkyo DS-A4 Bedienungsanleitung - Italienisch - 60 seiten

Onkyo DS-A4 Bedienungsanleitung - Spanisch - 32 seiten

Onkyo DS-A4 Bedienungsanleitung - Schwedisch - 60 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info