Bedienungsanleitung Onkyo HT-S9405THX (Seite 1 von 1) (Englisch)

492669

Zoom out

Zoom in

Vorherige Seite

1/1

Nächste Seite

Enjoying Home Cinema

The Home Cinema means that you can enjoy surround sound with a real sense of movement in your own home — just like being in

a movie theater or concert hall.

Connecting the Speakers

f cab

abFront left and right speakers (SKF-980)

They should be positioned facing the listener at about ear level, and equally

spaced from the TV. Angle them inward slightly so as to create a triangle, with

the listener at the apex.

c Center speaker (SKC-980)

Position it close to your TV (preferably on top) facing forward at about ear

level, or at the same height as the front left and right speakers.

deSurround left and right speakers (SKR-980)

Position them at the sides of the listener, or slightly behind, about 60 to 100 cm

above ear level. Ideally they should be equally spaced from the listener.

f Subwoofer (SKW-938)

The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)

channel and bass from the satellite speakers when a crossover is specified. The

volume and quality of the bass output from your subwoofer will depend on its

position, the shape of your listening room, and your listening position. In

general, a good bass sound can be obtained by installing the subwoofer in a

front corner, or at one-third the way along the front wall, as shown.

Corner

position

1/3 of wall

position

Red

White Green

Front left

speaker

Center speaker

Gray

Front right

speaker

Surround

left

speaker

Surround

right

speaker

Speaker Connection Precautions

Read the following before connecting your

speakers:

• Turn off your receiver before making any

connections.

• Pay close attention to speaker

wiring polarity. Connect positive

(+) terminals to only positive (+)

terminals, and negative (–)

terminals to only negative (–) terminals. If

the speakers are wired incorrectly, the sound

will be out of phase and will sound

unnatural.

• Be careful not to short the positive and negative

wires. Doing so may damage your amp.

Note

• When you connect the surround back and front

high speakers, prepare for it separately.

Powered

subwoofer

Blue

Specifications

■ Powered Subwoofer (SKW-938)

■ Front Speakers (SKF-980)

■ Center Speaker (SKC-980)

■ Surround Speakers (SKR-980)

Specifications and appearance are subject to change without

prior notice.

THX and the THX logo are trademarks of THX Ltd. which

Note

For non-magnetic shielded speakers:

Try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to

30 minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field,

thereby removing any discoloration effects.

Type Acoustic suspension

Rated output power (IEC)

125 watts minimum continuous power,

6 ohms, driven at 100 Hz with a maximum

total harmonic distortion of 1 %

Input sensitivity/impedance 280 mV / 20 kΩ

Frequency response 20 Hz to 100 Hz

Cabinet capacity 49 L

Dimensions (W × H × D) 380 mm × 444 mm × 429 mm

(incl. grille and projection)

Weight 15.5 kg

Drivers unit 30 cm Cone Woofer

Power supply AC 230 V, 50 Hz

Power consumption 137 W

Grille Fixed

Other Auto Standby function

Non-magnetic shielding

Type 2 Way Acoustic suspension

Impedance 8 Ω

Maximum input power 130 W

Sensitivity 83 dB/W/m

Frequency response 50 Hz to 45 kHz

Crossover frequency 2 kHz

Cabinet capacity 7.5 L

Dimensions (W × H × D) 158 mm × 433 mm × 199 mm

(incl. grille and projection)

Weight 5.3 kg

Drivers unit 12 cm A-OMF Cone Woofer × 2

2.5 cm Soft Dome Tweeter × 1

Term ina l Binding post (Banana type supported)

Other Magnetic shielding

Type 2 Way Acoustic suspension

Impedance 8 Ω

Maximum input power 130 W

Sensitivity 83 dB/W/m

Frequency response 50 Hz to 45 kHz

Crossover frequency 2 kHz

Cabinet capacity 7.5 L

Dimensions (W × H × D) 433 mm × 158 mm × 199 mm

(incl. grille and projection)

Weight 5.3 kg

Drivers unit 12 cm A-OMF Cone Woofer × 2

2.5 cm Soft Dome Tweeter × 1

Terminal Binding post (Banana type supported)

Other Magnetic shielding

Type 2 Way Acoustic suspension

Impedance 8 Ω

Maximum input power 130 W

Sensitivity 81 dB/W/m

Frequency response 50 Hz to 45 kHz

Crossover frequency 2 kHz

Cabinet capacity 4.6 L

Dimensions (W × H × D) 200 mm × 275 mm × 169 mm

(incl. grille and projection)

Weight 3.5 kg

Drivers unit 13 cm A-OMF Cone Woofer × 1

2.5 cm Soft Dome Tweeter × 1

Terminal Binding post (Banana type supported)

Other Non-magnetic shielding

■ Front

■ Rear

Caution

• The front grille is not designed to be removed so does not attempt

to remove it forcibly, as this will damage it.

Note

• The Auto Standby function turns the subwoofer on when the input signal

exceeds a certain level. If the Auto Standby function does not work

reliably, try slightly increasing or decreasing the subwoofer output level on

your receiver.

• If the Standby/On indicator lights (both red and blue LEDs) several

seconds or minutes after the sound output stopped, this means that the amp

protection circuit has been activated. In this case, set the OUTPUT LEVEL

control to the center position, and disconnect the power cord from the AC

outlet. Wait at least 10 seconds, and then reconnect the power cord. If that

doesn’t solve the issue, contact your Onkyo dealer.

Setting the Subwoofer Level

Make sure the SKW-938 subwoofer’s output

level control is set at the “THX-POSITION”.

You can then adjust the level as needed.

Powered subwoofer (SKW-938)

Subwoofer

RCA cable 3.0 m

Standby/On indicator

Red:Subwoofer in standby mode

Blue:Subwoofer on

With the Auto Standby function, the

SKW-938 automatically turns on when

an input signal is detected in Standby

mode. When there’s no input signal for

a while, the SKW-938 automatically

enters Standby mode.

OUTPUT LEVEL control

This control is used to adjust the

volume of the subwoofer.

LINE INPUT

This RCA input should be connected to

the subwoofer pre out on your AV

receiver with supplied RCA cable.

To AC outlet

POWER switch

Press this switch to the ON position to

turn on the power. Press it to the OFF

position to turn off the power.

5.1ch Home Cinema Package

Wall Mounting

Using the Cork Stoppers for a More Stable Platform

Front speakers (SKF-980) Center speaker (SKC-980) Surround speakers (SKR-980)

Front speakers

Speaker cables 3.5 m

Center speaker

Speaker cable 3.0 m

Surround speakers Speaker cables 8.0 m

Cork stoppers (12 pcs.) for front and

center speakers

To mount the front/surround speakers vertically, use

the keyhole slot shown to hang each speaker on a

screw that’s securely screwed into the wall.

To mount the center speaker horizontally, use the two

keyhole slots shown to hang each speaker on two

screws that are securely screwed into the wall.

Caution

• A mounting screw’s ability to support a speaker

depends on how well it’s anchored to the wall. If you

have hollow walls, screw each mounting screw into a

stud. If there are no studs, or the walls are solid, use

suitable wall anchors. Use screws with a head diameter

of 9 mm or less and a shank diameter of 4 mm or less.

With hollow walls, use a cable/pipe detector to check

for any power cables or water pipes before making any

holes.

• Leave a gap of between 5 mm and 10 mm between the wall and the base

of the screw head, as shown. (We recommend that you consult a home

installation professional.)

We recommend using the supplied cork stoppers to achieve the best possible

sound from your speakers. The cork stoppers prevent the speakers from

moving, providing a more stable platform.

■ Attaching and detaching the speaker grilles

The front, center and surround

speakers have detachable grilles.

See the right illustrations to attach

or detach them.

(White)

(Red)

(Green)

(Blue)

(Gray)

Keyhole slot

Speaker

terminals

SKF-980

Speaker terminals

Keyhole slots

SKC-980

Keyhole slot

Speaker

terminals

SKR-980

SKF-980 SKR-980

Keyhole slots for

wall mounting

Keyhole slots for wall mounting

260 mm

SKC-980

Wall

5 to 10 mm

Cork stoppers

Bottom of the

SKF-980

Bottom of the SKC-980

Removal

Replacement

Y1103-2

SN 29400482A

* 2 9 4 0 0 4 8 2 A *

HTP-938/HTP-948

Onkyo HT-S9405THX Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo HT-S9405THX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info