161046
20
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
20
Troubleshooting
If you have any trouble using the T-4355, look for a solution here. If you can’t resolve the issue yourself, contact your
Onkyo dealer.
Can’t turn on the T-4355.
Make sure that the power cord is properly plugged into the wall outlet (page 14).
Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
There’s no sound.
The T-4355 is not connected properly. Check all connections and correct as necessary.
The wrong input source is selected on your amplifier. Check your amplifier’s input source setting. Refer to your
amplifier’s manual.
Make sure the amplifier’s volume control is not set to minimum.
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset all
stations, or the ST indicator doesn’t light up when tuned to a stereo FM station.
Check the antenna connections.
Change the position of the antenna.
Move the T-4355 away from a nearby TV or computer.
Move power cords and speaker cables as far away as possible from the tuner’s antenna.
Cars or airplanes can cause noisy interference.
The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
Try setting FM mode to mono.
When listening to an AM station, noise may be heard when you operate the remote controller.
If none of the above improves the reception, install an outdoor antenna.
Settings such as radio presets were deleted.
Backup data can be stored incorrectly or destructed, and lead to a malfunction if either of the following operations is
performed:
- turning off the power immediately after an operation.
- repeating the fast power on/off switchings.
When a malfunction occurred due to those operations, initialize T-4355 to its factory defaults (see below), then set
radio presets or other settings again.
The A-9355/A-9155’s remote controller doesn’t work.
Point the remote controller at the A-9355/A-9155’s remote sensor (page 9).
To use , you must make an connection and an audio connection between the A-9355/A-9155 and T-4355
(page 11).
Power
Audio
Radio
Remote Controller
The T-4355 contains a microcomputer for signal processing and control functions. In very rare
situations, severe interference, noise from an external source, or static electricity may cause it to
lockup. In the unlikely event that this should happen, unplug the power cord, wait at least five
seconds, and then plug it again.
To reset the T-4355 to its factory defaults, turn it on and, while holding down the [FM MODE]
button, press the [DISPLAY] button. “CLEAR” will appear on the display.
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Onkyo t-4355 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Onkyo t-4355

Onkyo t-4355 Bedienungsanleitung - Deutsch, Holländisch, Schwedisch - 64 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info