Bedienungsanleitung Onkyo TX-NR801E (Seite 3 von 97) (Englisch)

553770

Zoom out

Zoom in

Vorherige Seite

1/97

Nächste Seite

Precautions

1. Recording Copyright

Unless it’s for personal use only, recording copyrighted

material is illegal without permission of the copyright

holder.

2. AC Fuse

The AC fuse inside the TX-NR801/TX-NR801E is not

user-serviceable. If you cannot turn on the TX-NR801/

TX-NR801E, contact your Onkyo dealer.

3. Care

Occasionally you should dust the TX-NR801/TX-

NR801E all over with a soft cloth. For stubborn stains, use

a soft cloth dampened with a weak solution of mild deter-

gent and water. Dry the TX-NR801/TX-NR801E immedi-

ately afterwards with a clean cloth. Don’t use abrasive

cloths, thinners, alcohol, or other chemical solvents,

because they may damage the ﬁnish or remove the panel

lettering.

4. Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST

TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure

that the voltage in your area meets the voltage requirements

printed on the TX-NR801/TX-NR801E’s rear panel (e.g., AC

230 V, 50 Hz or AC 120 V, 60 Hz).

The Worldwide model has a voltage selector for compatibility

with power systems around the world. Before you plug in this

model, make sure that the voltage selector is set to the correct

voltage for your area.

For USA, Canadian and Australian models

Setting the [STANDBY/ON] switch to STANDBY does not

fully shutdown the TX-NR801/TX-NR801E. If you do not

intend to use the TX-NR801/TX-NR801E for an extended

period, remove the power cord from the AC outlet.

For British Models

Replacement and mounting of an AC plug on the power supply

cord of this unit should be performed only by qualiﬁed service

personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance with

the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this apparatus

may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the ter-

minal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the

terminal which is marked with the letter L or coloured red.

IMPORTANT

A 5 ampere fuse is ﬁtted in this plug. Should the fuse need to

be replaced, please ensure that the replacement fuse has a rat-

ing of 5 amperes and that it is approved by ASTA or BSI to

BS1362. Check for the ASTA mark or the BSI mark on the

body of the fuse.

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR

THE SOCKET OUTLET IN YOUR HOME THEN THE

FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF

AND DISPOSED OF SAFELY. THERE IS A DANGER OF

SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG

IS INSERTED INTO ANY 13 AMPERE SOCKET.

If in any doubt, consult a qualiﬁed electrician.

For U.S. Models

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s

attention to Section 820-40 of the NEC which provides guide-

lines for proper grounding and, in particular, speciﬁes that the

cable ground shall be connected to the grounding system of the

building, as close to the point of cable entry as practical.

FCC Information for User

CAUTION:

The user changes or modiﬁcations not expressly approved by

the party responsible for compliance could void the user’s

authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection

against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio fre-

quency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio com-

munications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television recep-

tion, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

For Canadian Models

NOTE:

THIS CLASS B DIGITAL APPARATUS COM-

PLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH

WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle Canadien

REMARQUE:

CET APPAREIL NUMÉRIQUE DE LA

CLASSE B EST CONFORME À LA NORME NMB-003 DU

CANADA.

Sur les modèles dont la ﬁche est polarisée:

ATTENTION:

POUR ÉVITER LES CHOCS ÉLEC-

TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE

LA FICHE DANS LA BORNE CORRESPONDANTE DE LA

PRISE ET POUSSER JUSQU’AU FOND.

For European Models

Declaration of Conformity

We,

ONKYO EUROPE

ELECTRONICS GmbH

LIEGNITZERSTRASSE 6,

82194 GROEBENZELL,

GERMANY

GROEBENZELL, GERMANY

ONKYO EUROPE ELECTRONICS GmbH

I. MORI

declare in own responsibility, that the ONKYO product

described in this instruction manual is in compliance with the

corresponding technical standards such as EN60065,

EN55013, EN55020 and EN61000-3-2, -3-3.

Onkyo TX-NR801E Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info