216200
7
Zoom out
Zoom in
Vorherige Seite
1/7
Nächste Seite
7
If you experience a problem with your
projector, please refer to the following
information. If a problem persists, please
contact your local reseller or service
center.
Image Problems
No image appears on-screen
Ensure the cables/charger/
battery are correctly and securely
connected.
Ensure the pins of connectors are
not crooked or broken.
Make sure the projector is
switched on.
Image is out of focus
Adjust the Focus Dial.
Make sure the projection screen
is between the required distance
7.9 to 103.8 inches (0.2 to 2.636
meters) from the projector. See
page 5.
Image is too small or too large
Move the projector closer to or
further from the screen.
Image is reversed
Select “Settings-->Projection” from
the OSD and adjust the projection
direction.
Audio Problems
No sound
Press the VOLUME + button. (See
page 3.)
tr o u B l e S h o o t I n g
Battery Problems
Battery capacity is low
Remove the battery and clean the
connectors.
The battery is worn out and needs
to be replaced. See page 3.
LED Indicator
Message
LED (Red)
Operation
Charge enabled without battery
Battery Charging
Charge Complete
:Off / :Flash / :On
Message Reminders
Out of the range
High battery consumption
Please charge the battery. (See page
3)
co m p a t I B I l I t y mo D e
Computer
Mode Resolution
V-Sync
(Hz)
H-Sync
(kHz)
VGA
640x480 60 31.5
SVGA
800x600 60 37.9
Video
NTSC: M(3.58MHz), 4.43MHz
PAL: B, D, G, H, I, M, N
or
Menu/Enter
Volume +/Up
Volume -/Down
<Note> Supported format
Composite AV: NTSC, PAL
VGA: 640x480@60Hz, 800x600@60Hz
Component: 480i/p
ho W t o US e t h e Me n u - ex t e r n a l So u r c e In p u t (co m p o S I t e av, vga, co m p o n e n t )
Input signal source
Bright mode: Full lamp power.
ECO: Standard lamp power.
Front Desktop.
Rear Desktop.
Front Inverted.
Rear Inverted.
4x3 aspect ratio.
3x2 aspect ratio.
Battery is at full capacity.
Battery is at mid capacity
Battery is at low capacity
Image setting, you can adjust
Frequency, Phase and H. Position
functions.
H. Position: adjust the horizontal
position.
Phase: change the display data
frequency to match the frequency
of your computer’s graphic card.
Use this function only if the image
appears to icker vertically.
Frequency: synchronize the signal
timing of the display with the
graphic card. If the image appears
to be unstable or ickers, use this
function to correct it.
Composite or
Component source
VGA source
<Note>
Only for VGA input source.
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Optoma pk102 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info