EN
6
CHANGE SETTINGS
1. Press and hold MODE for 2 seconds to enter
setting mode.
2. Press
or to change settings.
3. Press
MODE to confirm.
TABLE STAND OR WALL MOUNT
Use the stand on the back of the product, or mount it
on a wall with a nail.
THERMO-HYGRO SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.
SET UP SENSOR
1. Open the sensor battery compartment with a small
Phillips screwdriver.
2. Insert the batteries, matching the polarity as
shown in the battery compartment.
NOTE It is recommended that you use alkaline
batteries with this product for longer performance.
However, in colder climates, if the unit is exposed to
cold temperatures i.e. 10°F (-12°C) to -40°F (-40°C), it
is recommended that you use lithium batteries.
SWITCH OPTION
SWITCH Channel 1 - 3. If you are using
more than one sensor, select
a different channel for each
sensor.
3. Set the channel. The switch is located in the battery
compartment.
4. Place the sensor near the main unit. Press
RESET
on the sensor. Then, press and hold MEMORY
and CHANNEL on the main unit to initiate signal
sending between the sensor and the main unit.
The reception icon on the main unit will blink for
approximately 3 minutes while it is searching for
the sensor. (Refer to the Data Transmission section
for more information.)
